Page 1
Operating and installation instructions Cooker hood DA 396 DA 399 en - GB, AU, NZ To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time.
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment.
Warning and Safety instructions Safety with children This appliance complies with all This appliance is only intended for relevant local and national safety use by adults who have read these requirements. Inappropriate use instructions. can, however, lead to personal injury and damage to property.
Page 5
Miele authorised person in accordance the data plate correspond with the with current national and local safety on-site electricity supply, otherwise the regulations.
Page 6
Warning and Safety instructions Do not connect the appliance to the Using at the same time as other mains electricity supply by a heating appliances that depend on multi-socket unit or an extension lead. the air from the room These do not guarantee the required safety of the appliance (e.g.
Page 7
The conversion kit is available from the Miele Spare Parts Department. Take care when ventilating the room through an open window that ventilation is not impaired by a closed blind or curtain.
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé...
Page 9
Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
Page 11
Guide to the appliance Extension piece Hob lighting switch Tower Sliding switch for the fan Canopy To switch on, slide the switch to the required setting. Control panel Depending on the intensity of the Grease filter cooking vapours, levels "1" to "3" are Recirculation grille usually sufficient for normal cooking.
Modes of operation The cooker hood works with . . . air extraction: . . . air recirculation: (available as an optional extra with a conversion kit and charcoal filter: see "Technical Data") The air is drawn in and cleaned by the grease filters and directed outside.
(in countries where this is steel, glass, plastic and chrome applicable). without the use of chemicals. Avoid: A range of Miele branded cleaning and conditioning agents are available to – cleaning agents containing soda, order through your Miele Dealer / acids, chlorides or solvents, Chartered Agent, the Miele Spare Parts –...
Cleaning and care Important for appliances with lacquered housing (special finish) It is very difficult to clean this type of surface without causing minor marks to the surface material. This can become particularly noticeable with darker colours and if there is halogen lighting in the kitchen.
Page 15
65°C programme, ensuring the spray arm is not obstructed. If a Miele dishwasher is being used, select the Sensor wash programme. ^ Use a mild dishwasher detergent.
It is designed to absorb cooking odours, and is fitted in the canopy above the grease filters. New filters can be purchased from your Miele Dealer / Chartered Agent or from the Miele Spare Parts Department. See back cover for contact details, and "Technical data"...
Cleaning and care ^ First remove the grease filters from Changing a halogen lamp the cooker hood. Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that – it is switched off at the wall socket and the plug is withdrawn, or –...
For recirculation mode, only a connection socket needs to be fitted. Connection for air extraction C 150 mm, or C 125 mm with reducing collar. DA 396 DA 399...
– 650 mm above gas hobs and cookers If this cooker hood is installed above a Miele Wok CS 1028 CombiSet appliance, a minimum safety distance of 760 mm must be maintained between the burner and the lower edge of the cooker hood.
Page 21
Installation 3 protective sheets for use when fitting the tower. 2 hose clips 7 screws 5 x 40 mm and for securing the exhaust ducting. 7 x S 8 plugs for securing the retaining 1 reducing collar plates to the wall. for exhaust ducting C 125 mm.
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the installation sheet.
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to protect and local safety regulations the appliance with a suitable residual...
Connection for air extraction Important: To avoid the danger If the exhaust ducting is secured to of toxic fumes, please observe the the exhaust stub by a hose clip, Warning and Safety instructions. ensure that it is fitted correctly. Do This is especially crucial when using not overtighten.
Connection for air extraction Important: If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated.
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent – The Miele Customer Contact Centre (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance.