Connecting Interface Cables And Verifying Connectivity - Cisco ASA 5580 Quick Start Manual
Hide thumbs
Also See for ASA 5580:
- Cli configuration manual (2164 pages) ,
- Configuration manual (1822 pages) ,
- Hardware installation manual (84 pages)
Table of Contents
Advertisement
4
Connecting Interface Cables and Verifying Connectivity
Connect to the Management 0/0 interface so that you can use ASDM to manage the ASA.You
Step 1
can connect the PC directly with an Ethernet cable, or connect the PC and the ASA to the same
management network. Make sure the PC is configured to obtain an IP address using DHCP.
The ASA 5580 has 2 management interfaces (Management 0/0 and Management 0/1);
however, only Management 0/0 is configured for use.
If you want to use the CLI, connect your PC to the console port, and see the CLI configuration
guide for more information.
Step 2
Connect your networks to the appropriate ports.
The ASA 5580 has nine expansion slots. Slots 3 through 8 support PCI Express network
interface adapters. Slots 1, 2, and 9 are reserved. Your exact configuration depends on the
configuration you purchased.
PS2
UID
Check the LINK/ACT indicators to verify interface connectivity.
Step 3
Interface
Reserved
expansion slots
PCI-E x4
PCI-E x8
PCI-E x4 PCI-E x8
9
8
7
6
5
Unsecured
Network
Reserved
PCI-E x4
PCI-X 100 MHz
4
3
2
1
CONSOLE
Secured
Network
PS1
1
MGMT0/1
MGMT0/0
Management PC
5
- Quick Links:
- Launching Asdm
- Advanced Configuration
Hide quick links:
Advertisement
Table of Contents
