Deviations From Standard - IBM DJSA-210 - Travelstar 10 GB Hard Drive Specifications
2.5 inch ata/ide hard disk drive
Hide thumbs
Also See for DJSA-210 - Travelstar 10 GB Hard Drive:
- Quick installation manual (2 pages)
Table of Contents
Advertisement
9.0 Deviations from standard
The device conforms to the referenced specifications, with deviations described below.
The interface conforms to the Working Document of Information Technology, AT Attachment with Packet
Interface Extension (ATA/ATAPI-5) Revision 2 dated December 13, 1999, with deviation as follows:
Standby Timer
Write Verify
S.M.A.R.T. Return Status
Standby timer is enabled by STANDBY command or IDLE command. The
value in the Sector Count register shall be used to determine the time
programmed into the Standby timer. If the Sector Count register is zero then
the Standby timer is set to 109 minutes automatically.
WRITE VERIFY command does not include read verification after write
operation. The function is the same as WRITE SECTORS command.
S.M.A.R.T. RETURN STATUS subcommand does not check advisory
attributes. This means that the device will not report a threshold exceeded
condition unless the prefailure attributes exceed their corresponding
thresholds. For example, a Power-On Hours Attribute never results in a
negative reliability status.
Travelstar 32GH/30GT/20GN hard disk drive specifications
63
Hide quick links:
Advertisement
Table of Contents
