Table of Contents
Advertisement
Quick Links
Architect™ Series Outdoor Built-In Side Burner
IMPORTANT:
Read and save these instructions.
IMPORTANT:
Installer: Leave Installation Instructions with the consumer.
Consumer: Keep Installation Instructions for future
reference.
Save Installation Instructions for local electrical inspector's
use.
Write the model and serial numbers in space provided below before
installing or using outdoor Side Burner. The numbers are stamped on
the identification label, located on bottom flange of the control panel.
they are also located on the model/serial number plate, located on the
side panel.
Model # ______________________ ______
Serial # __________________________ __
INSTALLATION INSTRUCTIONS
AND USE AND CARE GUIDE
Model KSBN220SSS
Quick Reference
Table of Contents:
Pages
6 Architect™ Series Built-In Outdoor Side
6 L.P. Gas Conversion
For the way it's made
®
®
Part No. 9763758
Advertisement
Table of Contents
Related Manuals for KitchenAid Architect KSBN220SSS
Summary of Contents for KitchenAid Architect KSBN220SSS
-
Page 1: Table Of Contents
INSTALLATION INSTRUCTIONS AND USE AND CARE GUIDE Architect™ Series Outdoor Built-In Side Burner Model KSBN220SSS Quick Reference Table of Contents: Pages 2 Outdoor Built-In Side Burner Safety 4 Installation Requirements 4 Tools and Parts 4 Location Requirements 4 Product Dimensions... -
Page 2: Outdoor Built-In Side Burner Safety
OUTDOOR BUILT-IN SIDE BURNER SAFETY FOR YOUR SAFETY FOR YOUR SAFETY If you smell gas: • Do not store or use gasoline or other flammable vapors and liquids in the • Shut off gas to the appliance. vicinity of this or any other appliances. •... - Page 3 IMPORTANT SAFETY INSTRUCTIONS 1. Do not install portable or built-in grills in or on a recreational 11. The L.P. gas supply cylinder to be used must be: vehicle, portable trailer, boat or in any other moving installa- • constructed and marked in accordance with the tion.
-
Page 4: Installation Requirements
INSTALLATION REQUIREMENTS WARNING Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed Fire Hazard • Level Do not use side burner near combustible materials. •... -
Page 5: Enclosure Cutout Dimensions
(305 m) above sea level. Orifi ce conversion is required. (5.7 cm) location at Contact KitchenAid Experience Center. rear of side burner • Refer to the model/serial rating plate for information on the type of gas that can be used. If this information does not agree with the type of gas available, check with your local gas supplier. -
Page 6: Outdoor Side Burner Installation
Line pressure testing: Testing above 1/2 psi (3.5 kPa) or 14 inches (35.5 cm) W.C. (gauge): INSTALLATION INSTRUCTIONS • The side burner and its individual shutoff valve must be disconnected from the gas supply piping system during any Outdoor Side Burner Installation pressure testing of that system at test pressures greater than 1/2 psig (3.5 kPa). -
Page 7: Check And Adjust The Burners
• If local codes permit, use a flexible stainless steel tubing 2. Gently move Side Burner completely into enclosure. gas connector, design-certified and marked “outdoor” by 3. Go to “Check and Adjust the Burners” section. CSA International, to connect the side burner to the rigid gas supply line. -
Page 8: Outdoor Side Burner Use
“OFF” and wait 5 minutes before relighting. If any burners do not light after attempting to manually light L.P. gas cylinder, if converted them, contact the KitchenAid Customer Experience Center. See the “Gas Supply Requirements” section. Replacing the Igniter battery •... -
Page 9: Cleaning
Cleaning Interior • Cleaning should always be followed by rinsing with clean, General Tips warm water. • Use a mild liquid detergent or all-purpose cleaner, following IMPORTANT: Before cleaning, make sure all controls are off label instructions. Rinse with clean water and dry completely and the burners are cool. -
Page 10: Warranty
For one year from the date of purchase, when this grill is operated and maintained according to instructions attached to or furnished with the product, KitchenAid will pay for factory specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a KitchenAid designated service company. -
Page 11: Requesting Assistance Or Service
If you need to order replacement parts, we rec om mend that you only use factory-authorized parts. These parts will fit right and work right, because they are made to the same exacting spec i fi ca tions used to build every new KitchenAid appliance. - Page 12 ® Part No. 9763758 © 2006 KitchenAid. ® Registered Trademark/Trademark of KitchenAid U.S.A. Printed in U.S.A. 01/2006 Prepared by KitchenAid, Benton Harbor, Michigan 49022...