Power Saving Mode - Fujitsu fi-7160 Operator's Manual
Image scanner
Hide thumbs
Also See for fi-7160:
- Getting started manual (8 pages) ,
- Operator's manual (210 pages) ,
- Getting started (9 pages)
Table of Contents
Advertisement
Chapter 1 Scanner Overview
1.8 Power Saving Mode
Power saving mode keeps the power consumption low when
the scanner has not been used for a certain period of time.
If the scanner is left powered on for 15 minutes without being
used, it automatically enters power saving mode.
When the scanner enters power saving mode, the LCD on the
operator panel switches off. The [Power] button remains lit in
green.
To resume from power saving mode, perform one of the
following:
Load a document in the ADF paper chute (feeder)
Press any button on the operator panel
Note that pressing the [Power] button for more than 2 seconds will
turn the power off.
Perform scanning from an application
The scanner is turned off automatically if it is left on for a
certain period of time without being used, reducing the power
consumption until the next scan.
To prevent the scanner from being turned off automatically,
clear the [Power off after a certain period of time] check box in
[Device Setting] on the Software Operation Panel. For details,
refer to
"Waiting Time to Enter Power Saving Mode [Power
saving]" (page
202).
To turn the power back on after turning the power off
automatically, press the [Power] button on the operator panel.
For details, refer to
"1.3 Turning the Power ON/OFF" (page
25).
.
ATTENTION
The scanner may not enter power saving mode if there was a
document remaining on the paper path. In that case, remove the
document.
For details, refer to
"8.1 Paper Jam" (page
For some applications, the scanner may not be turned off even if the
[Power off after a certain period of time] check box is selected.
If the scanner is automatically turned off while you are using the
image scanning application, exit the application before turning the
power on.
HINT
By using one of the following, the waiting time for entering power saving
mode can be changed.
Use the Operation Panel ([17: Power saving] in the [Settings Menu]
screen).
For details, refer to
"4.2 Settings Menu" (page 66)
Use the Software Operation Panel.
For details, refer to
"Waiting Time to Enter Power Saving Mode
[Power saving]" (page
202).
Contents
Introduction
Scanner
Overview
128).
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
36
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
