Welcome & Congratulations WELCOME TO THE WORLD OF ELECTROLUX Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You find some examples on the cover in this manual.
General Safety Instructions GENERAL INFORMATION FOR COOKING APPLIANCES You MUST read these warnings carefully before installing or using the appliance. If you need assistance, contact our Customer Care Centre. Keep this instruction book for future reference and ensure it is passed on to any new owner.
Page 6
General Safety Instructions For hygiene and safety reasons, this appliance should be kept clean at all times. A build-up of fats or other foodstuff could result in a fire. Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite.
Grill Features 1. Roll top grill hood 8. Warming shelf 2. Grilling/Cooking surface 9. Infrared back burner 3. Side Shelf 10.Electronic ignitors: main, rear infrared & side burner 4. Control knob: back infrared burner 11. Cart with door 5. Control knobs: main burners 12.
Grill Assembly Battery IMPORTANT: Remove all protective plastic film from Fig. 1 stailess steel parts prior to assebly/use. This film is Spring installed at the factory to Locking Mounting Bracket Cylinder prevent damage that could occur during shipment and handling. Fig.
Side shelf SIDE SHELF AND SIDE BURNER ATTACHMENT Loosen the bolts on the side of the grill attach the shelf by Fig. 5 allowing the bolt fall through the large opening in the the keyhole slots. Then slide the shelves downward until the bolts are resting the top of the key hole slots.
Page 10
Grill Assembly INTERIOR PARTS INSTALLATION 1. Check to make sure the bottom Flavor Grids are correctly installed Fig. 9 in the cutouts and around the ignitors, as they may have shifted during shipment. Bottom Flavor Grids in between burners (See Fig. 9) 2.
Built-In Instructions for model EGL4401X The Electrolux Grill: model EGL4401X can be installed as a WARNING built-in Grill. If installed as a built-in Grill, the Grill surround must be constructed of Non-combustible material. PLANNING AND DESIGN Start by identifying the number and size of components you want to include: Grill, side burner, access doors for storage or other items you may wish to furnish such as: refrigerator, sink, warming drawer.
Page 12
10 cm from the Grill. The ignitor plate (included with the model EGL4401X), fits over the standard electrical box once mounted in the structure. (See drawing on following page). The ground wire for the ignitor needs to be grounded to a metal structure in order for the ignitor to work.
Page 13
Built-In Instructions for model EGL4401X Note: Make sure to use a Side cutouts are needed on each side to feed ignitor wires to the ignitor plates and allow non-combustible base and access to side gas connections . sides for the structure (Size: 25 cm high x 12.5 cm long, set 1...
Gas Requirements For the correct installation of the GENERAL INFORMATION connection kit to the grill it is necessary Never attach an unregulated gas line to screw the exit junction of the kit to the appliance. Connection to an placed at the end of the flexible hose unregulated gas line can cause to the gas inlet of the grill.
Page 15
Gas Requirements L.P. TANK INFORMATION Never use a dented or rusted L.P. tank or cylinder with a damaged valve. Cylinders must not be stored in a building, garage, or any other enclosed area. L.P. TANK USE • When turning the L.P. tank on, make sure to open the valve SLOWLY two (2) complete turns to insure proper gas flow.
Pre Operation GENERAL INFORMATION Although all gas connections on the grill are leaked tested at the factory prior to shipment, a complete gas tightness check must be performed at the installation site due to possible mishandling in shipment, or excessive pressure unknowingly being applied to the unit.
Using the Grill GRILL LOCATION Do not use the grill in garages, breezeways, sheds or any enclosed area. Never operate the grill in enclosed areas as this could lead to a carbon monoxide buildup, which could result in injury or death. Place the grill on a level surface. Avoid moving the grill while it is operation.
Lighting the Grill Back Knob Knob Knob Knob Knob BEFORE LIGHTING Infrared nr. 5 nr. 4 nr. 3 nr. 2 nr. 1 Important! WARNING Before Lighting... Check the gas supply line for cuts, wear or abrasion. Always keep your face and body as far away from the grill as possible when lighting.
Page 19
Lighting the Grill MATCH LIGHTING CONTROL KNOB LAYOUT: If by chance the electronic ignitor does not light the burner, the burner The control knob may be lit with a match. Keep your bezel has stamped face as far away from the Grill surface markings for the as possible and pass a lit, long stem HIGH and LOW...
Using the Rotisserie & Side Burners Note: ROTISSERIE KIT is an accessory and must be purchased separately and is only available on some markets. The grill rotisserie system is designed to cook items from the back using infrared heat. The rotisserie burner is an infrared type which provides intense searing radiant heat.
Page 21
Using the Rotisserie & Side Burners Note: ROTISSERIE KIT is an accessory and must be purchased separately and is only available on some markets. ATTACHING THE ROTISSERIE The motor is mounted on a bracket on the left side of the grill by sliding the motor over the bracket with the cord facing the back of the grill.
Page 22
Using the Rotisserie & Side Burners Note: ROTISSERIE KIT is an accessory and must be purchased separately and is only available on some markets. ROTISSERIE LIGHTING Open the lid. Push and turn the control knob counter clockwise to the “HIGH” position. Wait 5 seconds. Then press and hold the electronic ignitor button.
Page 23
Using the Rotisserie & Side Burners SIDE BURNER LIGHTING Push and turn the control knob to the “HIGH”position and immediately press and hold the electronic ignitor button. You’ll hear a snapping sound. It may be necessary to hold the electronic starter button for about 4 seconds.
Care and Maintenance DRIP TRAY The drip tray located below the grill, inside the cart, should be cleaned periodically to prevent heavy buildup of debris. NOTE: Allow the drip tray to cool before attempting to clean. COOKING GRATES The cooking grates can be cleaned immediately after cooking is completed and after turning off the flame.
Troubleshooting GENERAL TROUBLE SHOOTING You should inspect the burners at least once a year or immediately if any of the following conditions occur: The smell of gas in conjunction with the burner flames appearing yellow. The Grill does not reach temperature. The burners make a popping noise.
Page 26
Troubleshooting PROBLEM SOLUTION Grill will not light when After opening tank valve, be sure one the igniter button is pushed. of theGrill control knobs is on high for at least 4 seconds while pushing ignitor button. Check tank fuel level. Check for loose wire connections.
Troubleshooting PROBLEM SOLUTION Check gas connection. Fuel level may be low. Flame is erratic Grill may be in need of cleaning. Check flavor grids and cooking grates for excess build-up. Ensure Grill is not placed directly in path of wind. Flare-Ups Be sure the drip tray is clean.
Warranty STANDARD GUARANTEE CONDITIONS We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: •...
Page 29
Warranty conditions EXCLUSIONS This guarantee does not cover: • Damage or calls resulting from transportation, im-proper use or neglect, the replacement of any light bulbs or removable parts of glass or plastic. • Costs incurred for calls to put right an appliance which is improperly installed or calls to appliances outside the United Kingdom.
Service and Spare Parts If the event of your appliance requiring service, or if you wish to purchase spare parts, please contact Service Force by telephoning: Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.