Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AEG FAVORIT 44082 i
Summary of Contents for AEG FAVORIT 44082 i
- Page 1 FAVORIT 44082 i Dishwasher User information...
- Page 2 Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appli- ance. The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety.
-
Page 3: Table Of Contents
Contents Operating Instructions ........Safety . -
Page 4: Operating Instructions
Operating Instructions 1 Safety Prior to using for the first time • Follow the ”Instructions for installation and connection”. Correct use • The dishwasher is only intended for washing domestic dishes. • Additions or modifications to the dishwasher are not permitted. •... -
Page 5: Diagram Of Appliance
Diagram of appliance Top Spray Nozzle Upper basket spray arm and floor spray arm Water hardness dial Dispenser for special salt Dispenser for detergent Dispenser for rinse aid Rating plate Filters Control panel ON/OFF button The ON/OFF button is used to turn the dishwasher on and off. - Page 6 Programme buttons End of cycle indicator Programme progress display Set delay timer Function buttons Select Control 3 in1 function indicators Function buttons: In addition to the pre-set dishwashing cycle, the following functions can also be set using these buttons: Function button 1 Set the water softener Activates/deactivates rinse aid inflow when Function button 2...
-
Page 7: Prior To Using For The First Time
Prior to using for the first time If you wish to use 3 in 1 detergent: – First read the section “Using 3in1 detergents”. – Do not fill up with special salt or rinse aid. If you do not use 3in1 detergent, before using for the first time 1. - Page 8 3. Press function button 1. The LED indicator for function button 1 will flash. The LED indicator for the end of the dishwashing cycle will flash simul- taneously: – The number of times that the LED indicator for the end of the dish- washing cycle flashes corresponds to the hardness setting.
-
Page 9: Adding Special Salt
Adding special salt To decalcify the water softener, it must be filled up with special salt. Use only special salt suitable for domestic dishwashers. If you do not use 3 in1 detergent, fill up with special salt: – Before using the dishwasher for the first time. –... -
Page 10: Filling Up With Rinse Aid
Filling up with rinse aid With rinse aid the rinsing water drains away better and so you get smear-free, gleaming dishes and clear glasses. If you do not use 3in1 detergent, fill up with rinse aid: – Before using the dishwasher for the first time. –... -
Page 11: Setting The Amount Of Rinse Aid Required
Setting the amount of rinse aid required Only change the amount dispensed, if smears, milky spots (reduce the amount) or dried on water spots (increase the amount) can be seen on glasses and dishes. (See section “If dishwashing results are not satisfac- tory”.) The dosage can be set from 1-6. -
Page 12: In Daily Use
3. Press function button 2. The LED indicator for function button 2 will flash. The indicator for the end of the dishwashing cycle will display the cur- rent setting: Rinse aid inflow activated when 3in1 Indicator for the end of the cycle is lit: Rinse aid inflow deactivated when Indicator for the end of the cycle is not lit: 3in1 on (factory setting) -
Page 13: Loading Cutlery
• Before loading the dishes, you should: – Remove the worst of the food residues. – Soak pans with burnt-on food residues. • When loading the dishes and cutlery, please note: – Dishes and cutlery must not impede the rotation of the spray arms. –... - Page 14 Pots, Pans, Large Plates Load larger and heavily soiled dishes and pans in the lower basket. (Max. diameter for plates 29 cm). To make it easier to load larger dish- es, the two plate rests on the right in the lower basket can be folded down.
-
Page 15: Adjusting The Height Of The Upper Basket
• The cup racks can be folded up out of the way for tall crockery items. • Lay or hang wine and brandy glasses in the slots in the cup racks. Adjusting the height of the upper basket Maximum height of dishes in the Upper basket Lower basket with upper basket raised... -
Page 16: Adding Detergent
Adding detergent Detergents remove the dirt from dishes and cutlery. The detergent must be added before the cycle starts. Only use detergent intended for do- mestic dishwashers. The detergent compartment is lo- cated on the inside of the door. 1. If the lid is closed: Press the release button. -
Page 17: Using 3In1 Detergents
Detergent tablets Detergent tablets from different manufacturers dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power during short cycles. Therefore please use dishwashing cycles with pre-wash when using detergent tablets. Using 3in1 detergents These products are detergents with a combined cleaning, rinsing and salt function. -
Page 18: Selecting The Dishwashing Cycle (Cycle Table)
Selecting the dishwashing cycle (Cycle Table) Programme Consumption sequence values Dishwashing- Suitable Type of cycle for: soiling Dinner serv- AUTOMATIC normally soiled, ice and • • • • (50°- 65°) dried-on food remains cookware Dishes, ex- 30 MIN just used, lightly to •... -
Page 19: Selecting A Programme
Selecting a programme When your dishes look like this, select: an intensive programme. a normal or energy-saving pro- gramme. a short programme (e.g. 30 minute programme). -
Page 20: Starting A Dishwashing Cycle
Starting a dishwashing cycle 1. Check that the spray arms can turn freely. 2. Turn the water tap on fully. 3. Close the door. 4. Press the ON/OFF button. 5. Select the desired cycle. The programme display lights up. One or two lights will flash in the programme progress display. -
Page 21: Setting The Delay Timer
Setting the Delay Timer Using the delay timer you can delay the start of a dishwashing cycle for 3, 6 or 9 hours. 1. Press the ON/OFF button. 2. Press the Delay Timer button repeatedly until the indicator next to the number of hours for which the start of the dishwashing cycle is to be delayed lights up, e. -
Page 22: Care And Cleaning
Care and cleaning Do not use furniture care products or aggressive cleaners. • When necessary, clean the dishwasher’s controls with a soft cloth and clean warm water. • Occasionally check the internal dispensers, door seal and water inlet filter (if fitted) for dirt and clean them, if necessary. Cleaning the filters The filters must be regularly checked and cleaned. - Page 23 5. Remove the flat filter (3) from the base of the washing compartment and clean both surfaces thoroughly. 6. Re-insert the flat filter. 7. Place the fine filter in the micro-fil- ter and fit the two together. 8. Insert the filter system in place and lock it by turning the handle clock- wise as far as it will go.
- Page 24 3. Place cleaned upper basket spray arm back in position against the connect- ing piece: press the two together firmly, until you feel them snap into place. Bottom spray arm 1. To remove bottom spray arm, pull it upwards out of its catch. 2.
-
Page 25: What To Do If
What to do if... Remedying small malfunctions If while the appliance is operating indicators on the control panel flash or are lit up as described in the following table, please consult this to find out how to remedy the fault. After remedying the fault that is flashing in the first or second rhythm in the programme progress display, press the button for the dishwashing cycle that had already started. - Page 26 Malfunction Possible cause Remedy the indicator for the end of the dishwashing cycle is Turn off the tap and The anti-flood system has flashing in rhythm 3 short contact the Customer been triggered. light signals one after anoth- Care department. The mains plug is not Plug in mains plug.
-
Page 27: If The Dishwashing Results Are Not Satisfactory
If the dishwashing results are not satisfactory The dishes are still dirty. • The wrong dishwashing cycle was selected. • The dishes were loaded is such a way that the dishwashing water did not reach all items. The baskets for the dishes must not be overload- •... -
Page 28: Disposal
Disposal Packaging material The packaging materials are environmentally friendly and can be recy- cled. The plastic components are identified by markings, e.g. >PE<, >PS<, etc. Please dispose of the packaging materials in the appropriate container at the community waste disposal facilities. Old appliance The symbol on the product or on its packaging indicates that this... -
Page 29: Technical Data
Technical data Capacity: 12 place settings including serving dishes Permitted water pres- 1-10 bar (=10-100 N/cm = 0.1-1.0 MPa) sure: Electrical connection: 230 V, 10 A, also see the rating plate on the right-hand side of the dishwasher’s interior door . Dishwashers that can be integrated and built-in Dimensions: 820 - 880 x 596 x 570 (H x W x D in mm) -
Page 30: Notes For Test Institutes
Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test cycle (see “Cycle Table”). Tests in accordance with EN 50242 must be carried out when the salt dispenser in the water softener and the rinse aid dispenser have been filled with salt and rinse aid respectively, and using the test cycle (see “Cycle Table”). - Page 31 Lower basket with cutlery basket Cutlery basket *) If there are cup racks in place on the lefthand side or if beer glass holders are in place, remove them.
-
Page 32: Installation And Connection Instructions
Installation and connection instructions 1 Safety information for the installation • Only transport the dishwasher in an upright position, otherwise salt water may run out. • Before using the dishwasher for the first time, check for any damage caused in transport. Do not under any circumstances connect an ap- pliance that is damaged. -
Page 33: Installing The Dishwasher
Installing the dishwasher • The dishwasher must be installed on a firm floor and adjusted to en- sure that it is stable and level in all directions. • To compensate for unevenness in the floor and to match the height of the appliance to that of sur- rounding units, extend the thread- ed feet using a screwdriver. -
Page 34: Connecting The Dishwasher
Connecting the dishwasher Connecting to the water supply • The dishwasher can be connected to cold and hot water supplies up to max. 60°C. • The dishwasher must not be connected to open hot water appliances or instantaneous water heaters. Permitted water pressure Lowest permitted water pressure: Consult your plumber if the water pres-... -
Page 35: Water Drainage
Water drainage Drain hose The drain hose must not be kinked, crushed or entangled. Connecting the drain hose: – Maximum permitted height: 1 metre. – Minimum required height: 40 cm above the bottom edge of the ap- pliance. Extension hoses •... -
Page 36: Electrical Connection
Electrical connection Details about the voltage, type of supply and the fuses required are to be found on the rating plate. The rating plate is located on the right- hand inner edge of the dishwasher door. To isolate the dishwasher from the mains, pull out the mains plug. Important: –... -
Page 37: Guarantee Conditions
Guarantee Conditions Belgium DECLARATION OF GUARANTEE TERMS. Our appliances are produced with the greatest of care. However, a defect may still occur. Our con- sumer services department will repair this upon request, either during or after the guarantee peri- od. The service life of the appliance will not, however, be reduced as a result. This declaration of guarantee terms is based on European Union Directive 99/44/EC and the provi- sions of the Civil Code. -
Page 38: Customer Service Centres
These guarantee terms are only valid for appliances purchased and used in Belgium. For exported appliances, the user must first make sure that they satisfy the technical conditions (e.g.: voltage, frequency, installation instructions, type of gas, etc.) for the country concerned and that they can withstand the local climatic and environmental conditions. -
Page 39: Service
Service In the event of technical faults, please first check whether you can remedy the problem yourself with the help of the operating instruc- tions (section “What to do if…”). If you were not able to remedy the problem yourself, please contact the Customer Care Department or one of our service partners. - Page 40 USD 14 billion in more than 150 countries around the world. AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG 822 612 633-00-140305-00 Subject to change without notice...