Table of Contents
Advertisement
125980803 gb.qxp
2005-11-22
Operating sequence
Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door (see picture).
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does
not get caught between the door and filter.
5. Select the drying programme or time. The lights
"Drogen" ("Drying"), "Afkoelen" ("Cooling") and
"Einde" ("End")come on. The light of the
StartPpauze button flashes and the display
shows the duration of the programme.
6. If required, press the "Lage temp." ("Low
temperature") button and/or the "Zoemer uit"
("Buzzer OFF") button or the "Kort" ("Quick
drying") button.
7. Press the "Start/Puaze" ("Start/Pause") button:
the corresponding light stops flashing and drying
starts. Only the light "Drogen" ("Drying")
remains lit. If you have selected the delayed
start, the machine begins its countdown.
If the programme selector dial is turned to another
position, when the machine is running, the buzzer
will sound, the programme phase indicator lights
will flash.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (light "Afkoelen" ("Cooling") is on).
You may remove the laundry after this phase.
06:43
Page 9
The lights "Einde" ("End"), "Pluizenfilters"
("Filter cleaning") and "Waterhouder" ("Water
reservoir full") illuminate.
The display shows a static zero and the buzzer sounds.
8. If the laundry is not removed at the end of the
cycle, the dryer performs an anti-creasing
phase (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will stop
automatically at the end of the anti-creasing phase.
Lights "Einde" ("End"), "Pluizenfilters" ("Filter
cleaning") and "Waterhouder" ("Water reservoir
full") remain lit and the buzzer sounds every 10
seconds for 2 minutes.
The light of the Start/Ppauze button goes off and
a flashing zero appears on the display.
9. Turn the programme selector dial to "UIT"; all
the lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the selector dial to "UIT" all the lights
corresponding to the phases making up the
performed programme come on and the
display shows the duration of the programme.
After each use
• Clean the filters (see page 11).
• Empty the water reservoir (see page 12).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position "Afkoelen"
("Cooling") and wait until the end of this cooling
phase before removing the laundry. This will avoid a
build-up of heat inside the appliance.To do this first
turn the dial to "UIT" and then to "Afkoelen"
("Cooling") and depress Start/Pauze button .
Modifying the programme
To change a programme which is running, first
cancel it by turning the programme selector dial to
"UIT". Select the new programme and press the
Start/Pauze button.
9
- Quick Links:
- The Control Panel
Hide quick links:
Advertisement
Table of Contents
