GE JS998 Installation Instructions Manual
Self-cleaning radiant trivection electric slide-in range
Hide thumbs
Also See for JS998:
- Technical service manual (77 pages) ,
- Owner's manual (57 pages) ,
- Installation instructions manual (17 pages)
Table of Contents
Advertisement
Quick Links
!Insta"ation
lse' c ean
n°"a°
ant veO
on I
nstructlons
Electric Slide-In Range
JS998
I r-?-i Questions?
Call 800.GE.CARES
(800.432.2737)
or Visit our Website
at: www.GEAppliances.com
I
BEFORE YOU BEGIN
Read these
instructions
completely
and carefully.
• IMPORTANT - Save t hese
instructions
for local
inspector's
use.
• IMPORTANT - Observe all
governing
codes
and ordinances.
• Note to Installer
- Be sure to leave these
instructions
with
the Consumer.
• Note to Consumer
- Keep these
instructions
for future
reference.
• Skill
level - Installation
of this appliance
requires
basic mechanical
and advanced
electrical
skills.
• Completion
time
- 1 to 3 hours
• Proper
installation
is the responsibility
of
the installer.
• Product
failure
due to improper
installation
is not covered
under
the Warranty.
_WARNING
-
This appliance
must
be properly
grounded.
FOR YOUR SAFETY:
-&WARNING - For
p ersonal
safety,
do not use an extension
cord with
this
appliance.
Remove
house fuse or open circuit
breaker
before
beginning
installation.
Failure
to do so could result in serious
injury or
even death.
• All rough-in
and spacing
dimensions
must
be met for safe use of your
range.
Electricity
to the range
can be disconnected
at the outlet
without
moving
the range
if
the outlet
is in the preferred
location
(remove
lower
drawer).
FOR YOUR SAFETY: (cont.)
• To reduce
the risk of burns
or fire when
reaching
over hot surface
elements,
cabinet
storage
space above
the cooktop
should
be
avoided.
If cabinet
storage
space is to be
provided
above
the cooktop,
the risk can
be reduced
by installing
a range
hood that
protrudes
at least 5" beyond
the front
of
the cabinets.
Cabinets
installed
above
a
cooktop
must
be no deeper
than
13;'
• Be sure your
appliance
is properly
installed
and grounded
by a qualified
technician.
• To prevent
damage
to the door
and to
prevent
excessive
microwave
leakage,
do NOT remove
the door
on the oven.
ANTI-TIP
DEVICE
Z_WARNING - Toreduce therisk
of tipping,
the appliance
must
be secured
by
properly
installed
Anti-Tip
bracket
packed
with
this appliance.
• If the Anti-Tip
device
supplied
with
the
range
does
not fit this application,
use the
universal
Anti-Tip
device
WB2X7909.
-&WARNING -
• All ranges
can tip
• Injury to persons
could result
• Install Anti-Tip
bracket
packed
with range
• See Installation
Instructions
• If you pull the range
out and away
from
the
wall
for any reason,
make
sure the Anti-Tip
bracket
is engaged
when
the range
is
pushed
back against
the wall.
229c4053P547-4
31-10558-4
05-04 JR
Advertisement
Table of Contents
Related Manuals for GE JS998
Summary of Contents for GE JS998
- Page 1 !Insta"ation lse' c ean n°"a° ant veO on I nstructlons Electric Slide-In Range JS998 I r-?-i Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com BEFORE YOU BEGIN FOR YOUR SAFETY: (cont.) • To reduce the risk of burns...
-
Page 2: Prepare To Install The Range
Installation Instructions PREPARE TO INSTALL THE RANGE TOOLS YOU WILL NEED MATERIALS NEEDED 1/8" Drill Bit and Safety Glasses Electric or Hand Drill Lag Bolts Anchor Sleeves (Extension May Be (For Concrete Floors Only) Required) Tape Measure Adjustable Wrench (for 1-7/16" Nut) (UL Approved 40 or 50 AMP) Pencil 4-Wire Cord... -
Page 3: Pre-Installation
To obtain kits, visit the GE Website or call NOTE: To prevent damage to the door and the GE Answer Center (800.432.2737), to prevent... -
Page 4: Cutout Clearances
Installation Instructions PREPARE TO INSTALL THE RANGE (cont.) PRE-INSTALLATION CUTOUT AND REQUIRED CLEARANCES NOTE: The oven below the cooktop meets UL requirements for 0" clearance to back and side walls and cabinets. Wall coverings, counters and cabinets around the range must withstand heat (up to 194°F) - Page 5 Installation Instructions PRE-INSTALLATION CUTOUT AND REQUIRED CLEARANCES (cont.) STANDARD INSTALLATION Wall 1/4" Min. Flat Flat Area 25" 23-3/16" Typically 9/16" Min. Flat ..29-15/16"-30-1/16" "_ Smooth • Center the 30" wide opening over the adjacent If the construction of your cabinet cannot cabinets...
-
Page 6: Electrical Connections
Installation Instructions ELECTRICAL CONNECTIONS ELECTRICAL REQUIREMENTS Use only a 3-conductor or a 4-conductor UL-listed range cord. These cords may be CAUTION: provided with ring terminals on wire and a For personal safety, strain relief device. do not use an extension cord with this appliance. -
Page 7: Power Cord And Strain Relief Installation
Installation Instructions POWER CORD AND STRAIN For power cord installations only (see the next step if using conduit), assemble RELIEF INSTALLATION the strain relief in the hole. Insert power cord through the strain relief Remove the wire cover tighten. Allow enough slack to easily (on the back of the... - Page 8 Installation Instructions ELECTRICAL CONNECTIONS (cont.) 3-WIRE POWER CORD 4-WIRE POWER CORD INSTALLATION INSTALLATION -& WARNING: WARNING: The neutral The neutral wire of ground wire of the power cord must be the supply circuit must be connected connected to the neutral terminal located the neutral terminal...
-
Page 9: Installation
Installation Instructions 4-WIRE CONDUIT INSTALLATION 3-WIRE CONDUIT INSTALLATION Loosen the three lower terminal screws Loosen the 3 lower terminal screws from the terminal block. Insert the center bare from the terminal block. Remove wire (white/neutral) tip through ground screw and ground plate and retain bottom center... -
Page 10: Install The Anti-Tip Bracket
Installation Instructions INSTALL THE ANTI-TIP BRACKET REPLACE THE WIRE COVER INSTALLING THE BRACKET IN WOOD OR CONCRETE Replace the wire cover INSTALLATION--WOOD CONSTRUCTIONS (on the back of the range) by replacing the 2 screws • Locate the centers of the 4 holes identified removed earlier. -
Page 11: Install The Range
Installation Instructions INSTALL THE RANGE SLIDE RANGE INTO OPENING [_] SLIDE RANGE INTO OPENING (cont.) Position the range in front of the cabinet Plug the range cord into the receptacle. opening. Locate the cord in the back of the range in a manner that it will not touch or be... -
Page 12: Operation
Installation Instructions INSTALL THE RANGE (cont.) REPLACE THE STORAGE r_-4]FINAL INSTALLATION DRAWER CHECKLIST * Check to make sure the circuit breaker Place the drawer rail on the guides, closed (RESET) or the circuit fuses it stops. Push the drawer in until replaced. -
Page 13: Alternate Construction
Installation Instructions ALTERNATE CONSTRUCTION OPTIONAL MAINTOP FILLER OPTIONAL MAINTOP FILLER OR BACKGUARD OR BACKGUARD KIT (cont.) If counter opening extends to the wall, it will If you use the filler kit, place the metal filler require Maintop Filler Kit (supplied with piece supplied... - Page 14 Notes...
- Page 15 Notes...
- Page 16 Printed in the United States...