Electrolux ICON E24CM75GSS Installation Instructions Manual page 15
Built-in coffee maker
Hide thumbs
Also See for ICON E24CM75GSS:
- Technical & service manual (82 pages) ,
- Use & care manual (44 pages) ,
- Use and care manual (44 pages)
Table of Contents
Advertisement
Installation
15
Put the two (2) cabinet
glide assemblies,
and
shims if necessary,
as
shown on the inside
surfaces
of the cabinet.
Position
them 3 1/2"
(9.0cm)
from the front
edge of the cutout
opening.
4" (100mm)
Cabinet Back Cutout for
Circulati on
Insert the screws
in
the holes of the glides
without
tightening
them
completely.
3 1/2"
Make sure the outside
distance
between
the
fixing angles
is 22 1/8"
(56.2cm)
and that the
glides are level. Change
the number
of shims or
adjust the fixing angles
as necessary.
3
(9.0cm)
18"
(45.7cm)_
IMPORTANT:
Make sure that the glides
are level.
•
Tighten
all of the screws.
Make sure that the power cord and water feed line can be fed freely through
the back wall.
In order to avoid overheating
the coffee
maker,
make an opening
of at least 3
15/16" (10.0cm)
at the back of the cabinet to allow air to circulate.
Advertisement
Table of Contents
