Table of Contents
Advertisement
The Filler Cap Is Difficult to Remove
• Sometimes a vacuum can form in
Press here
of the filler cap to relieve the vacuum.
Fan Enclosure or Tank Does Not Fit on Base
• Make sure that the cord or other
• Is the cord routed correctly? The
Cord
behind
tabs
Cord
exit
notch
cord storage compartment, as
shown above.
• Apply 100% pure petroleum jelly
the tank,
to the filler cap gasket. Wipe off
especially
any excess.
if it has not
been seated
on the base
for a long
period of
time. Press
the button
in the center
• New filters are shipped flat and must
objects are
be "rounded" before installation.
not trapped
Gently pull the filter into a round
under the fan
shape, being careful not to tear it.
Once the filter is properly rounded,
enclosure
or tank.
install it and lower the fan enclosure
into place (as described on page 6).
cord should
be pressed
completely
into the cord
exit notch.
Any excess
cord should
be completely
behind the
tabs in the
New filter
Rounded filter
15
Advertisement
Table of Contents
