Table of Contents
Advertisement
Symptom
All Component Select buttons flash twice.
After programming the Power-On command of a
component, pressing that Component Select button does
not function correctly.
The System Control function or Control Programme
function does not work properly.
Customer Service
If you have any questions or
problems concerning the Remote
Commander that are not covered
in this manual, please call the
customer remote helpline. The
number is mentioned in the
warranty card.
Helpline available
Remedy
• The Hold function is on. Unlock the Hold function (page 25).
• A Learning function has already been set on the Component Select
button. If a Learning function has been set (page 12), you can
programme the Power-On function on the Component Select button
(page 20) but the Power-On setting will not work until you clear the
"learned" function. Erase the "learned" function after setting the
Power-On function.
This function is for Sony components only.
• When you programme a System Control function or Control
Programme function, make sure to follow the correct steps (pages 21,
23).
• Change the direction the Remote Commander is aimed. If the problem
persists, position the programmed components closer together.
• If the remote control receivers of the components are too far apart, or if
something is blocking the signals between them, some of the
components may not operate in sequence even after you press the
programmed button. If some of the components do not operate
correctly because of the above or any other reason, position the
components back to the way they were before you set the System
Control function or Control Programme function. Failure to do this can
result in incorrect operation when you use these functions again.
• Some components may not always be powered on by the System
Control function or Control Programme function. This is because the
power of the component turns on and off alternately when receiving
the power on/off signal. In this case, check the operating component's
power on/off state before using the System Control function.
• If you change the AV brands' component code number (page 8) set on a
Component Select button that has been programmed for a series of
commands by the Control Programme function, the new signal will be
transmitted when you press the corresponding Component Select
button.
• The intervals between steps may be too short. Depending on the
components, you may need to insert an interval between consecutive
controls. You can insert an interval by changing the order of pressing
the buttons. (You can insert an interval between steps when
programming the Component Select button.)
• If a SYSTEM CONTROL button or a Component Select button has
already "learned" a remote control signal (page 12), you can
programme a System Control function (System Control Macro) or a
Control Programme function (Component Macro), but the function will
not work until you clear the Learned function. To clear the Learned
function, see "Changing or erasing the function of a "learned" button"
on page 16.
29
Hide quick links:
Advertisement
Table of Contents
