Table of Contents
Advertisement
125987350.qxp
2007-01-09
20 electrolux something not working
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes to
indicate that the machine is not working.
Once the problem has been eliminated, press the
programme. If after all checks, the problem persists, contact your local Service
Centre.
Malfunction
Dryer does not
work.
Drying results
unsatisfactory.
Loading door
does not close.
15:02
Page 20
Possible cause
Mains plug is not plugged in
or fuse is not working
correctly.
Loading door is open.
Have you pressed the START/
PAUSE button?
Wrong programme selected.
Lint filter clogged.
Heat exchanger clogged with lint.
Incorrect volume of laundry.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at
installation site differs from
Fine strainer not in place
and/or large mesh filter not
locked in place.
Start/Pause
button to restart the
Solution
Plug in at mains socket. Check fuse
in fuse box (domestic installation).
Close loading door.
Press the START/PAUSE button
again.
Select a different programme the next
time you dry (see "Overview of
programmes" section).
Clean lint filter.
Clean heat exchanger.
Observe recommended loading
volumes.
Uncover ventilation slots in
base area.
Clean inside surface of drum and
drum ribs
Re-programme standard setting for
degree of drying
Install fine strainer and/or
snap large mesh filter into
place.
Advertisement
Table of Contents
