Table of Contents
Advertisement
2.1. Basic Operation Flow
This section shows the basic steps for using this product to operate a device connected
2
to the serial port from a remote terminal.
Step 1
Step2
Step3
Step4
Step5
Advanced version only
Step6
SERVIS IP-Serial
14
1p Converter
User's Guide
Connect this product.
Connect this product to a network, target device, and terminal device
(local console).
Refer to
1.3 Cable Connection (page 7)
Set the DIP switches.
Set the front DIP switches according to the environment where the product is
to be used.
Refer to
2.2 DIP Switch Settings (page 16)
Start/configure the emulator application.
Configure the communication software of the local console according to
the interface specifications of this product.
Refer to
2.3 Emulator Application Settings (page 16)
Start up this product.
Turn on the power switch of this product to start it.
Refer to
2.4 Starting the Product (page 17)
Log in to this product from the local console.
Enter the "User Account" and "Password" to log in to this product. By default,
there is an administrator account "admin" with the password of "admin".
Refer to
2.5 Login via the Local Console (page 18)
Insert the CF card for saving log information.
Insert the CF card, which came with this product, into the CompactFlash slot,
and then prepare it to be used by executing the cfformat command.
Refer to
2.6 Preparing the CF Card (page 19)
Advertisement
Table of Contents
