Table of Contents
Advertisement
Using Remote Control
Point the remote control to the infrared receiver on the DVD video camera/recorder. The remote
controllable distance is up to 16 feet (5 m).
Infrared receiver
:
Note
•
When using the remote control, make sure that the
infrared receiver on DVD video camera/recorder is not
exposed to direct sunlight or any intense light. If the
infrared receiver is subject to light stronger than the
infrared light from remote control, the DVD video
camera/recorder cannot be operated by remote control.
•
If there is an obstacle between the remote control and
infrared receiver on DVD video camera/recorder,
remote control may not be possible.
VIEWING SUBJECT THROUGH VIEWFINDER
1
Pull out the viewfinder.
2
Turn the diopter control knob to adjust the
focus to suit your eyesight.
:
Note
•
If no image appears in viewfinder, refer to "Check 6" on
page 164.
•
If the LCD monitor is open approximately 90°, the
viewfinder will be off.
•
Focusing will not be correct unless the viewfinder is
pulled out.
34
10˚
10˚
15˚
15˚
•
The DVD video camera/recorder uses the "VCR2"
remote control code of Hitachi VCRs. If you use a Hitachi
VCR, etc. with remote control code set to "VCR2", a VCR
placed near the DVD video camera/recorder will also be
operated by the remote control: To prevent this, change
the remote control code of the VCR.
Diopter control
Viewfinder
Pull out the finder until a
click is heard.
- Quick Links:
- Instruction Manual
Hide quick links:
Advertisement
Table of Contents
