Unattended Start Protection - Hitachi SJ100 Instruction Manual
Sj100 series
Hide thumbs
Also See for SJ100:
- Instruction manual (160 pages) ,
- Service manual (75 pages) ,
- Quick reference manual (25 pages)
Table of Contents
Advertisement
4–18
Using Intelligent Input Terminals
Unattended Start Protection
If the Run command is already set when power is turned ON, the inverter starts running
immediately after powerup. The Unattended Start Protection (USP) function prevents
that automatic startup, so that the inverter will not run without outside intervention.
When USP is active and you need to reset an alarm and resume running, either turn the
Run command OFF, or perform a reset operation by the terminal [RS] input or the
keypad Stop/reset key.
In the figure below, the [UPS] feature is enabled. When the inverter power turns ON, the
motor does not start, even though the Run command is already active. Instead, it enters
the USP trip state, and displays E13 error code. This requires outside intervention to
reset the alarm by turning OFF the Run command per this example (or applying a reset).
Then the Run command can turn ON again and start the inverter output.
RUN command [FW, RV]
Alarm output terminal
Inverter output frequency
Inverter power supply
Option
Terminal
Code
Symbol
13
USP
Valid for inputs:
Required settings:
Notes:
•
Note that when a USP error occurs and it is
canceled by a reset from a [RS] terminal input, the
inverter restarts running immediately.
•
Even when the trip state is canceled by turning the
terminal [RS] ON and OFF after an under voltage
protection E09 occurs, the USP function will be
performed.
•
When the running command is active immediately
after the power is turned ON, a USP error will
occur. When this function is used, wait for at least
three (3) seconds after the powerup to generate a
Run command.
1
0
1
[USP] terminal
0
1
0
1
0
1
0
Alarm
Events:
display
Input
Function Name
State
Unattended Start
ON
Protection
OFF
C_01, C_02, C_03, C_04,
C_05, C_06
(none)
Alarm
Run
E13
cleared
command
Description
On powerup, the inverter will not resume a Run
command (mostly used in the US)
On powerup, the inverter will resume a Run
command that was active before power loss
Example (default input configuration shown for
–FU models; –FE and –FR models require input
configuration—see page 3–34):
USP
L
6
5
4
See I/O specs on page 4–6.
t
3
2
1
P24
- Quick Links:
- Configuring Drive Parameters
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
