Honeywell TN924W User Manual page 9

Weather information station

Hide thumbs

Table of Contents

Enlarged version

WEATHER STATION CONTROLS PANEL

Selects the next available mode clockwise

A. UP

Increases parameters

Activates manual search for atomic time signal

Enables or disables time alarms (W) and (S) and Ice

Warning Alarm

Selects the next available mode anti-clockwise

B. DOWN

Decreases parameters

Activates manual search for signals from the remote

weather sensors when depressed and held for 5 sec.

Toggles display between different modes

C. SET

If depressed and held, activates programming mode or

changes unit of selected parameter

Confirms programmed parameters

Recalls a different temperature and humidity channel

D. CHANNEL

from 1 to 5

Activates the remote temperature and humidity channels

auto-scan feature

Allows displaying the memory records of the moon

E. MEM

phase, temperature, humidity, rainfall and wind data

If depressed and held, clears memory of collected

records

Activates a searching mode of the sunrise and sunset

history records

Allows displaying the SEA LEVEL pressure history

F. HISTORY

Allows displaying all available alarms – for time,

G. ALARM/CHART

temperature, rainfall and wind.

If depressed and hold, allows entering into the alarm

programming mode for selected parameter

When depressed and hold in pressure/forecast mode,

allows viewing of the temperature and humidity history

charts

PLACEMENT

•

For best Weather Radio reception place the main unit where it can receive

NWS signals and you can hear the weather broadcast – do not place it near

any large obstructions or surfaces such as refrigerators, metal cabinets, etc

•

For best Weather Station reception make sure that the main unit is locating

within the operating range of all remote weather sensors

•

Ideally the remote weather sensors should be mounted within the line of sight

from the main unit

•

Transmission range may be affected by trees, metal structures and electronic

appliances

•

Test reception before permanently mounting all remote weather sensors

Avoid placing the main unit in the following areas:

•

Direct sunlight and surfaces emitting and radiating heat, such as heating ducts

or air conditioners

•

Areas with interference from the wireless devices (such as cordless phones,

radio headsets, baby listening devices) and electronic appliances

OPERATION

Once the main unit is powered, the Weather Station display will show all available LCD

segments for 2 seconds.

The Weather Radio display line will remain blank for 2 seconds, then SIGNAL LOSS

statement with RF reception symbol will appear and radio will start scanning through all 7

NOAA channels. If the reception is successful, it will detect and lock on the available

channel.

IMPORTANT: All of the Weather Station display functions will be locked, allowing setting

pressure parameters and local altitude. The locked display will show the pressure icon

and abbreviation "inHg" flashing in Pressure Window, indoor temperature and humidity

readings in Temperature/Humidity Window, default time in Time Window and a default

sunset/sunrise time in the Sunrise/Sunset Window.

If pressure and altitude are not configured during this time, the Weather Station will

self-calibrate in a few minutes and show the default settings for the pressure and altitude

(sea level) and then all remote weather sensors readings.

To set the pressure & altitude units and program your altitude, use the main unit control

panel, located on the back.

NOTE: When adjusting altitude in feet or meters, be noted that the last small

digit is not a decimal but a whole number.

Example: "

0" feet means 350 feet (three hundred fifty feet).

Table of Contents

This manual is also suitable for:

Tn924wd - main display unit

Honeywell TN924W User Manual page 9

Related Manuals for Honeywell TN924W

Related Products for Honeywell TN924W

This manual is also suitable for:

Table of Contents