Installation Check - LG DLEX3885 Series Service Manual

Electric & gas dryer

Hide thumbs Also See for DLEX3885 Series:

Table of Contents

9-2 Installation check

This feature allows you to quickly verify that the exhaust system is adequate for the normal function of the

dryer. The check takes only two minutes. The results of the check are displayed in the FlowSense

display window as shown below

(Fig. 1). The dryer must be at room temperature for this test to be reliable. To perform this test, start the

machine in standby mode (power off). Press and hold both the DAMP DRY BEEP and the TEMP CONTROL

buttons together while turning on the dryer with the POWER button i.e. Press together the three buttons

DAMP DRY BEEP + TEMP CONTROL + POWER. The dryer will start and run for 2 minutes while it checks

temperatures. At the end of this short cycle, it will display the results as follows.

Fig.1

After Installation Check,

If duct shows....

PRESS TOGETHER

(Three buttons)

If NO Bars are shown in the

display, ductwork is free from

any blocking or restrictions.

If 4 Bars are shown in the display,

ductwork is blocked and need to

be cleaned immediately.

Table of Contents

Show Quick Links

Table of Contents