Contents Important Safety Notice Your Micro Hi-Fi System Introduction What’s in the box Overview of the main unit Overview of the remote control Connect Connect speakers Connect power Get started Prepare the remote control Turn on Play disc Play options Adjust volume level and sound effect Adjust volume level Enhance bass...
1 Important h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Safety i Protect the power cord from being walked on or pinched, particularly at Know these safety symbols plugs, convenience receptacles, and the point where they exit from the apparatus.
• Remove batteries when the unit is not level before your hearing adapts and leave used for a long time. it there. • Batteries (battery pack or batteries installed) shall not be exposed to To establish a safe volume level: excessive heat such as sunshine, fire •...
Any changes or modifications made to this We have tried to make the packaging easy to device that are not expressly approved by separate into three materials: cardboard (box), Philips Consumer Lifestyle may void the user’s polystyrene foam (buffer) and polyethylene authority to operate the equipment. (bags, protective foam sheet.)
Page 7
Note • The type plate is located on the bottom of the apparatus.
2 Your Micro Hi- Fi System Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.Philips.com/welcome. Introduction With this unit, you can: • enjoy audio from discs and other external devices • listen to radio stations...
Overview of the main unit • Start or pause play. j VOL +/- a STANDBY • Adjust volume. • Indicate the standby mode. k Display panel b POWER • Show current status. • Turn on/off the unit. • Switch to standby mode. l Disc compartment c SOURCE •...
Overview of the remote • Program radio stations. control k REPEAT • Play a track or all tracks repeatedly. l SOURCE • Select a source: disc, FM, or AUX. a POWER • Turn on/off the unit. • Switch to standby mode. b DBB •...
3 Connect Connect the AC power cable to the power outlet. Connect speakers Note • Insert the stripped portion of each speaker wire into the socket completely. • For optimal sound, use the supplied speakers only. • Connect only speakers with impedance that is the same or higher than the supplied speakers.
» The unit switches to the last selected Always follow the instructions in this chapter in source. sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The Switch to standby model number and serial number are on the Press POWER again to switch the unit to bottom of the apparatus.
5 Play disc Repeat play During play, press REPEAT repeatedly to select: • [r1]: play the current track repeatedly. Press SOURCE repeatedly to select the • [rA]: play all tracks repeatedly. disc source. To return to normal play, press REPEAT Open the disc compartment.
6 Adjust volume level and sound effect Adjust volume level During play, press VOL +/- to increase/decrease the volume level. Enhance bass During play, press DBB to turn on or off dynamic bass enhancement. Mute sound During play, press MUTE to mute or restore the volume.
7 Listen to radio Program radio stations manually Tune to a radio station Note • You can program a maximum of 20 preset radio Press SOURCE repeatedly to select FM stations. source. Press and hold for more than 2 Tune to a radio station. seconds.
8 Other features Listen to an external device You can listen to an external device through this micro Hi-Fi system. Press SOURCE repeatedly to select AUX source. Connect the supplied MP3 link cable to: MP3 LINK jack (3.5 mm) on the unit •...
• Fully extend the antenna. requesting service. If the problem remains unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.