Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Tascam CC-222MKIV
Summary of Contents for Tascam CC-222MKIV
- Page 1 D01226620B CC-222@%^ CD Recorder/Cassette Deck Professional OWNER'S MANUAL...
-
Page 2: Important Safety Precautions
CAUTION Changes or modifications to this equipment not expressly approved by TEAC CORPORATION for compliance could void the user's authority to operate this equipment. IN USA/CANADA, USE ONLY ON 120 V SUPPLY. TASCAM CC-222... -
Page 3: Important Safety Instructions
• Leave 1U of space above the unit for ventilation. • Allow at least 10 cm (4 in) at the rear of the unit for ventilation. TASCAM CC-222... -
Page 4: Safety Instructions
Less than 131.9mW (CD) and before inserting new batteries. 147.8mW (DVD) on the objective lens • Do not disassemble a battery. The acid inside the battery could harm skin or clothing. Wavelength: 785nm (CD) typical 661nm (DVD) typical Standard: IEC60825-1: 2007 TASCAM CC-222... -
Page 5: Table Of Contents
Cassette recorder section .......35 Basic recording .......... 22 Phono input and headphones ......36 General specifications ........36 Time display while recording ......23 Dimensional drawing ........ 37 Playing back tracks ..........23 Restricting the number of tracks ....23 Full disc .............23 TASCAM CC-222... -
Page 6: Introduction
• AA batteries for the remote control unit ......2 • Rack-mounting screw kit (screws and washers) .....1 • Owner’s Manual (this manual) ........1 The warranty is included at the end of this manual. Contact your TASCAM supplier if any of these items are missing. TASCAM CC-222... -
Page 7: Some Notes, Precautions And Environmental Considerations
IV. If it sticks to the turn- table, you will need a technician to get it out. Trademarks TASCAM is a trademark of TEAC Corporation, regis- • tered in the U.S. and other countries. MPEG Layer-3 audio coding technology licensed from •... -
Page 8: Handling Of Compact Discs
It is important that they are not stored in a location where direct sunlight will fall on them, and which is away from sources of heat such as radiators or heat-generating electrical devices. TASCAM CC-222... -
Page 9: About Finalizing
Selectable values (i.e. values in dB) or ON and OFF • When the alphanumeric portion of the display shows • selections (i.e. ) are shown in the following SRC>XXX a message, this is shown in the following typeface: typeface: Comp l ete TASCAM CC-222... -
Page 10: Use Of The Remote Control Unit
Do not use batteries of different specifications together. Do not attempt to recharge batteries that are non- • rechargeable. Do not open or disassemble batteries, throw them into a • fire or put them in water. NOTE The batteries are not supplied for Taiwan. TASCAM CC-222... -
Page 11: Features Of The Cc-222
“through”. Stands by for tape playback or record- Tape PAUSE key ing. Pressing this key again resumes the operation. TASCAM CC-222... -
Page 12: Rear Panel
RIA A PHONO INPUT (L , R) a nd G ND ter mina l Use these connectors to connect a record deck to the CC-222 IV. The destination of the signal is deter- mined by a menu item. TASCAM CC-222... -
Page 13: Display
” and “ ” are lit. “ ” also blinks until a REPEAT “B-point” is entered. This is always displayed except when record- INPUT 2 ing with the key. PHONO Shows the different sources LINE 2, DISC display TASCAM CC-222... -
Page 14: Rc-222Mkiv Remote Control Unit
Changes the time display for the disc DISPLAY key recording and playback. Repeated presses of this key shows different MENU key menu items. Used to confirm menu settings. ENTER key Allows the first 10 seconds of INTRO CHECK key TASCAM CC-222... -
Page 15: Menu Operation
32 and “Recording to disc from the RIAA PHONO inputs” on page 23 MP3 DIR MP3 directory “Playing back MP3 files” on page 20 OUT2 Assign the OUTPUTS2 jacks to TAPE TAPE “OUT2 setting” on page 33 or DISC TASCAM CC-222... -
Page 16: Disc Operations
On the remote control unit only, the search keys can be It is also possible to use the number keys on the remote used to ”fast-forward” and ”fast-rewind” through the disc. control unit to jump directly to a particular track: 1 To play tracks 1 through 9, simply press the appro- priate key (1 through 9). 2 To play a track whose number is higher than 9, press the +10 key an appropriate number of times to TASCAM CC-222... -
Page 17: Playback Modes
If you enter more than 99 program steps, the message 5 Repeat steps 3 and 4 above until the program is appears on the display. F u l l ! complete. If the total time programmed goes over 100 minutes, the 6 Press the key to start playback at the first PLAY message appears on the display. -- : -- program step. TASCAM CC-222... -
Page 18: Repeat Playback
(see “Search keys” on page 33). the mode and returns to normal playback. key also cancels the mode and stops playback. STOP NOTE This function is only possible using the remote control unit. TASCAM CC-222... -
Page 19: Pitch Control Playback
When using the key control function, the volume of the playback sound may occasionally sound like it is vibrating. This is a result of the key control algorithm working on the CD playback sound and is normal. TASCAM CC-222... -
Page 20: Playing Back Mp3 Files
PLAY On this unit, file name or MP3 TAG information (track title, artist name, etc.) can not be displayed. Program or Repeat playback can be operated in the selected directory also. The time display mode for MP3 is only [blank], showing elapsed time of the current track. TASCAM CC-222... -
Page 21: Recording Cds
If an attempt is made, the error the CC-222 IV’s internal frequency converter: SRC message will appear on the display. Not Fs44.1k! (Sampling Rate Convertor), converts the incoming frequency to 44.1 kHz. TASCAM CC-222... -
Page 22: Basic Recording
–16 dB on the meters (on other words, 0 is equivalent to 16 dBFS). 4 Press the key or the key to start re- PLAY PAUSE cording. Note that there is no need to “cue up” the recording position—the unit always finds the next available location on the disc and start recording to it. 5 Press the key to pause recording temporar- PAUSE ily. The pause indicator on the display appears. Pressing the or key again restarts PAUSE PLAY recording with a new track number. TASCAM CC-222... -
Page 23: Time Display While Recording
RIAA PHONO INPUT lights on the display, and the disc recorder enters standard manual recording procedure (“Basic recording” record standby mode. on page 22), except that the input option should be PHONO 4 Start playing back the record. selected using the key before recording starts. INPUT 1 SEL 5 Start recording on the disc by pressing the disc key. PLAY TASCAM CC-222... -
Page 24: Dubbing From Tape To Disc
DUB >VOL pears. 2 Turn the dial to select , the control is bypassed THRU and disabled. NOTE This setting applies only to dubbing procedures, not to other recordings. It is not possible to make this menu setting (or other menu settings) when dubbing is actually taking place. TASCAM CC-222... -
Page 25: Advanced Recording
DD mode, you need to make an extra track on the source media before recording. Recording starts level This part of the track may not be Stop of recording recorded S_LVL S_LVL level Last track Extra track time time TASCAM CC-222... -
Page 26: Synchronized Recording
Manually divide track While recording is taking place, press the key. RECORD The current track number is incremented by one. NOTE This operation cannot be applied while recording track 99. TASCAM CC-222... -
Page 27: Fade-In And Fade-Out
PROH (copy prohibited) which prevents any digital • copies being made from the recorded disc 1 Press the key repeatedly until the dis-play MENU shows , where is the current COPY I D > XXXX XXXX setting for copy-protection as shown above. TASCAM CC-222... -
Page 28: After Recording
Even if a CD-RW disc has been finalized, selecting an erase procedure will automatically unfinalize it prior to erasure. The disc may then have to be re-finalized. Remember that it is not possible to perform any erase procedures on a CD-R disc. TASCAM CC-222... -
Page 29: Erasing Tracks
ERASE XX : XX timer starts counting down. press the key. ERASE At the end of the countdown period, the word Com- 2 Turn the or use the keys until the MULTI DIAL SKIP plete appears briefly on the display, and the display display shows D I SC REFRESH? returns to the track/time display (of course, there 3 To refresh the disc, press the or the MULTI DIAL are no tracks, and the disc is at the start, with the key. ENTER total time of the disc available for recording). If you do not want to proceed with the refresh op- eration, press the key or key. ERASE STOP TASCAM CC-222... -
Page 30: Cassette Operating
The LINE OUTPUTS1 jacks always output the audio playback reaches the end of the disc, or the end of from th edisc. the tape as determined by the setting, REV MODE playback starts on the other unit. NOTE Media (tape or disc) can be changed in the unit that is not playing. 4 To stop playback and cancel the mode, press the key again. CD-TAPE CONT PLAY TASCAM CC-222... -
Page 31: Recording Operations
It is also not possible to enter the dubbing mode if the indicator flashes. tape is not in stop or record standby mode, or if the CD is not in stop or pause mode. The CD starts playback after the eight seconds at the start of the cassette. The indicator lights steadily. recording If the tape is in record standby mode, TASCAM CC-222... -
Page 32: Dubbing To Tape From The Middle Of A Cd
Erasing tapes Anything previously recorded on the tape will automatical- ly be erased when you make a new recording on it. It can also be erased by “recording” on it with the level INPUT control set to “0”. TASCAM CC-222... -
Page 33: Other Tape Functions And Features
AUTO tape or disc automatically when playing back or monitor- ing. However, note that if both are playing at same time, the cassette takes priority (the disc will not be heard through these outputs). TASCAM CC-222... -
Page 34: Reference And Specifications
Recorded content is being written to disc. TOC Reading Table of contents data is being read. REC Standby The unit is in recording standby mode. Blank Disc A blank recordable disc has been inserted. NO DISC A disc is not loaded into the unit. TASCAM CC-222... -
Page 35: Specifications
Fast winding time About 160 seconds (C-60) Line inputs 2 Unbalanced RCA Normal input level 0.28 V (-11 dBV) Input impedance 50 k Ø Line outputs 2 Unbalanced RCA Normal output level 0.46 V (-6.7 dBV) Output impedance 1k Ø TASCAM CC-222... -
Page 36: Phono Input And Headphones
U.S.A./Canada 120 VAC, 60 Hz U.K./Erope 230 VAC, 50 Hz Australia 240 VAC, 50 Hz Power consumption 35 W Dimensions (d x w x h) 295 x 483 x 138 (mm) 11.6 x 19.0 x 5.4 (in) Weight 7.2 kg (15.9 lb) TASCAM CC-222... -
Page 37: Dimensional Drawing
8 – Reference and specifications 1 – Introduction Dimensional drawing Illustrations and other depictions may differ in part from the actual product. • Specifications and external appearance may be changed without notification to improve the product. • TASCAM CC-222... - Page 38 Notes TASCAM CC-222...
- Page 39 Ce produit est sujet aux réglementations concernant la garantie légale dans le pays d’achat. En cas de défaut ou de problème, veuillez Your unit must be serviced by an authorized TASCAM service station in Except as specified below, this warranty covers all defects in materials contacter le revendeur chez qui vous avez acheté...
- Page 40 TEAC CORPORATION http://tascam.jp/ Phone: +81-42-356-9143 1-47 Ochiai, Tama-shi, Tokyo 206-8530 Japan TEAC AMERICA, INC. http://tascam.com/ Phone: +1-323-726-0303 7733 Telegraph Road, Montebello, California 90640 USA TEAC MEXICO, S.A. de C.V. http://teacmexico.net/ Phone: +52-55-5010-6000 Río Churubusco 364, Colonia Del Carmen, Delegación Coyoacán, CP 04100, México DF, México TEAC UK LIMITED http://tascam.eu/...