Speaker - IBM IntelliStation A Pro 6224 Hardware Maintenance Manual And Troubleshooting Manual
Hide thumbs
Also See for IntelliStation A Pro 6224:
- User manual (132 pages) ,
- Installation manual (106 pages)
Table of Contents
Advertisement
Speaker
v Read "Installation guidelines" on page 25.
v Read Appendix B, "Safety information," on page 117.
v Read "Handling static-sensitive devices" on page 25.
Important: Before you begin, make sure that you have a flat work surface
available next to the computer on which you can set down the drive cage (see step
5).
Complete the following steps to remove the speaker:
Speaker
Figure 26. Speaker replacement
64
IntelliStation A Pro Type 6224: Hardware Maintenance Manual and Troubleshooting Guide
1. Turn off the computer and attached devices; then, disconnect all power cords
and external cables.
Note: Removing the speaker might be easier if the computer is turned on its
side.
2. Remove the cover and support bracket (see "Replacing the side cover" on
page 27 and "Replacing the support bracket" on page 29).
3. Remove the front bezel (see "Replacing the bezel" on page 30).
4. Remove all adapters and set them on a static-protective surface.
5. Disconnect from the hard disk drives any cables, such as the SCSI cable, that
are too short to allow the drive cage to rest on a clean work surface at the side
of the computer.
Note: The illustrations in this document might differ slightly from your
hardware.
Card guide and retainer
bracket
Drive cage
PCI support
cage
Advertisement
Table of Contents
Troubleshooting
