Table of Contents
Advertisement
Available languages
Available languages
Before starting
WARNING! Please read the operator's
!
manual carefully and make sure you
understand the instructions before using the
machine.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
Make sure no unauthorised persons are in
the working area, otherwise there is a risk of
serious personal injury.
Check that the machine is assembled
correctly and do not show any signs of
damage. See instructions in the section
"Assembling and adjustments".
•
Perform daily maintenance. See instructions in the section
"Maintenance".
Before starting the saw, check that:
•
The incoming electrical cable has been connected to a
fuse rated at least 16 A.
•
All controls on the remote control have been set to zero
position. If this is not done, a message in the display will
prompt this when the start button is pushed.
Starting
•
Check that the emergency stop button on the power pack
and the stop button on the remote control are not pressed
by turning the them clockwise.
•
Turn the main switch to "1"-position.
14 –
English
STARTING AND STOPPING
•
The power pack is activated and this is shown by the
indicator light shining. If the water valve is set to "AUTO" it
is now shut off. This valve opens again when the blade
rotation is started.
•
Activate the remote control by pressing the "ON/OFF"
button.
ON/OFF
•
Set the required drive mode depending on if the power
unit will be used for wall sawing or wire cutting. (DRIVE
CHOICES>SET DRIVE CHOICES)
>>DRIVE CHOICES
SET GEAR
[- - -]
SET DRIVE MODE
[BLADE]
SET ROT. DIR.
[STANDARD]
SET FUSE
[32A]
•
Select the required direction of rotation. The direction of
rotation can only be altered when the blade/wire is not
moving. (DRIVE CHOICES>SET ROT. DIR.)
>>DRIVE CHOICES
SET GEAR
[- - -]
SET DRIVE MODE
[BLADE]
SET ROT. DIR.
[STANDARD]
SET FUSE
[32A]
OK
0
20 DEC
20:55
20 DEC
20:55
Advertisement
Chapters
Table of Contents
