Adjust Flame Height; Complete Installation; Adjust Surface Burner Flame - Whirlpool 30" Installation Instructions Manual

30" (76.2 cm) slide-in gas ranges

Hide thumbs Also See for 30":

Installation instructions manual (32 pages)

Installation instructions and use & care manual (28 pages)

Installation manual (7 pages)

Table of Contents

Available languages

Enlarged version

4. Apply masking tape to the end of a ³⁄₈" (1 cm) nut driver to

help hold the gas orifice spud in the nut driver while changing

it. Press nut driver down onto the gas orifice spud and

remove by turning the LP gas broil burner orifice hood

counterclockwise to remove. The hood will be stamped with

a "100."

5. Replace the "100" hood with a "155" hood. Install the Natural

gas broiler burner orifice hood, turning it clockwise until snug.

IMPORTANT: Do not overtighten.

A. Orifice hood

6. Place the broil burner on the broil burner orifice hood and

insert the broil burner ceramic igniter in the hole in the rear of

the oven.

7. Replace the flame spreader with all four tabs facing up and

the notches toward the rear of the oven.

8. Position the broil burner against the top of the oven and

attach it with 1 screw.

9. Replace the premium storage drawer, warming drawer or

baking drawer. See the "Remove/Replace Drawer" section.

10. Replace the oven door. See the "Oven Door" section.

11. Replace the oven racks.

Complete Installation (LP Gas to Natural Gas)

1. Refer to the "Make Gas Connection" section for properly

connecting the range to the gas supply.

2. Refer to the "Electronic Ignition System" section for proper

burner ignition and operation.

3. Refer to the "Adjust Flame Height" section for burner flame

adjustments.

IMPORTANT: You may have to adjust the low setting for each

cooktop burner.

Checking for proper cooktop, bake and broil burner flame is

very important. Natural gas flames do not have yellow tips.

4. Refer to "Complete Installation" in the "Installation

Instructions" section of this manual to complete this

procedure.

IMPORTANT: Make sure to save the orifices that have

just been replaced in the conversion.

Adjust Surface Burner Flame

Adjust the height of top burner flames. The cooktop "low" burner

flame should be a steady blue flame approximately ¼" (0.64 cm)

high. LP gas flames have a slightly yellow tip.

To adjust standard burner:

The flame can be adjusted using the adjustment screw in the

center of the valve stem. The valve stem is located directly

underneath the control knob.

If the "low" flame needs to be adjusted:

1. Light 1 burner and turn to lowest setting.

2. Remove the control knob.

Hold the knob stem with a pair of pliers. Use a small flat-

blade screwdriver to turn the screw located in the center of

the control knob stem until the flame is the proper size.

Turning the screw clockwise will increase the flame size, and

turning the screw counterclockwise will decrease the flame

size.

3. Replace the control knob.

4. Test the flame by turning the control from the low position to

the high position, checking the flame at each setting.

5. Repeat the previous steps for each burner.