D-Sub Cap Installation Procedure; Installing The Holder (J19-5485-12) And Speaker Hardware Fixture; Removing The Lithium Cell; Installing The Lithium Cell - Kenwood NX-700 Service Manual
Vhf digital transceiver
Hide thumbs
Also See for NX-700:
- Instruction manual (228 pages) ,
- Service manual (33 pages) ,
- Specifications (3 pages)
Table of Contents
Advertisement
NX-700/700H
■ D-sub cap installation procedure
To improve water resistance, fi t the D-sub cap into the
D-sub terminal hardware fi xture of the transceiver in the fol-
lowing order:
1. Fit the left side ( q ) of the D-sub cap into the hardware
fi xture.
2. Fit the right side ( w ) of the D-sub cap into the hardware
fi xture.
3. Fit the center ( e ) of the D-sub cap into the hardware
fi xture.
Verify that the D-sub cap is in close contact with the
hardware fi xture.
■ Installing the holder (J19-5485-12) and speaker
hardware fi xture (J21-8481-03)
1. Insert two tabs of the holder (J19-5485-12) into the hol-
lows in the top of the panel. ( q )
2. Push the two tabs of the holder in on the opposite side
of those in step 1 above and fi t them into the hollow in
the bottom of the panel. ( w )
Note: Push in the holder until it snaps in place.
3. Install the speaker holder onto the panel. ( e )
Note: To improve water resistance, fi t the panel into the
groove of the holder.
4. Place the speaker into the speaker holder.
Note: The speaker must not ride on the holder rib.
5. Place the spacer on the speaker.
6. Insert the hardware fi xture (J21-8481-03) into the hollow
of the panel as shown in Figure 7-3, then push two parts
of the hardware fi xture and fi t it into the hollow of the
top of the panel. (Fig. 7-3 r )
Note: Push in the hardware fi xture until it snaps in place.
7. Insert the speaker connector into the display unit con-
nector (CN902).
8. Place the speaker lead on the holder hook.
16
DISASSEMBLY FOR REPAIR
Fig. 6
Fig. 7-1
Spacer
Speaker
Speaker holder
Fig. 7-2
■ Removing the lithium cell (W09-0971-05)
Insert a screwdriver to groove of one side of the socket
(CN405) and pry the lithium cell up from the socket.
Fig. 8
■ Installing the lithium cell (W09-0971-05)
Insert a lithium cell into one side of the socket (CN405).
Push the lithium cell to insert the lithium cell into the
socket.
Fig. 9
Fig. 7-3
Hide quick links:
Advertisement
Table of Contents
