Table of Contents
Advertisement
WARRANTY
All Hanna Instruments meters are warranted
for two years against defects in workmanship
and materials when used for their intended
purpose and maintained according to instruc-
tions.
The probes are warranted for a period of
six months.
This warranty is limited to repair or replace-
ment free of charge.
Damages due to accident, misuse, tampering
or lack of prescribed maintenance are not
covered.
If service is required, contact the dealer from
whom you purchased the instrument. If under
warranty, report the model number, date of
purchase, serial number and the nature of the
failure. If the repair is not covered by the
warranty, you will be notified of the charges
incurred. If the instrument is to be returned to
Hanna Instruments, first obtain a Returned
Goods Authorization Number from the Cus-
tomer Service department and then send it
with shipment costs prepaid. When shipping
any instrument, make sure it is properly pack-
aged for complete protection.
To validate your warranty, fill out and return
the enclosed warranty card within 14 days
from the date of purchase.
All rights are reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
Hanna Instruments reserves the right to
modify the design, construction and ap-
pearance of its products without advance
notice.
50
CE DECLARATION OF CONFORMITY
Recommendations for Users
Before using these products, make sure that they are entirely suitable for the environment
in which they are used.
Operation of these instruments in residential area could cause unacceptable interferences
to radio and TV equipments, requiring the operator to take all necessary steps to correct
interferences.
The trimmers are sensitive to electrostatic discharges. It is recommended to use anti-static
screwdrivers.
Unplug the instrument from the power supply before replacing the fuse. External cables to
be connected to the rear panel should end with cable lugs.
To maintain the EMC performance of this equipment, use the recommended cables
mentioned on this instruction manual.
Any variation introduced by the user to the supplied equipment may degrade the instruments'
EMC performance.
To avoid electrical shock, do not use these instruments when voltages at the measurement
surface exceed 24VAC or 60VDC.
To avoid damages or burns, do not perform any measurement in microwave ovens.
51
- Quick Links:
- Table of Contents
- Connections
Hide quick links:
Advertisement
Table of Contents
