Server Power Features; Turning On The Server - IBM eServer xSeries 235 Type 8671 Option Installation Manual

Hide thumbs Also See for eServer xSeries 235 Type 8671:

Table of Contents

Server power features

This section contains information about how to properly turn your server on and off.

Turning on the server refers to the act of plugging the power cords of your server

into the power source and starting the operating system.

You can turn on the server in any of the following ways:

v If the power cords are connected to a power source, you can press the

v If the server is turned on and a power failure occurs, the server will restart

v If ac power is present, the server is in Standby mode, and the server is

v If ac power is present, the server is in Standby mode, and an optional Remote

v When you plug in your server for the first time, Wake on LAN

v If your server was previously turned on, it must be properly placed in Standby

Complete the following steps to manually turn on the server:

1. Review the information in "Safety" on page v.

2. Turn on all external devices, such as the monitor.

3. Plug the server power cords into the power source.

4. Press the power-control button on the front of the server.

power-control button on the front of the server.

Notes:

1. You can install a circular disk over the power-control button to prevent

accidental manual power-off. This disk, known as the power-control button

shield, comes with your server.

2. After you plug the power cords of your server into the electrical outlets, wait

approximately 20 seconds before pressing the power-control button. During

this time, the system-management adapter is initializing; therefore, the

power-control button does not respond.

automatically when power is restored.

connected to an ASM interconnect network that contains at least one system with

an optional Remote Supervisor Adapter installed, the server can be turned on

from the Remote Supervisor Adapter user interface.

Supervisor Adapter is installed in the server, the server can be turned on from

the Remote Supervisor Adapter user interface.

server.

mode for the Wake on LAN feature to turn on the server.

Note: While the server is powering up, the power-on LED on the front of the

server is lit.

can turn on the

Chapter 2. Installing options

Table of Contents