3 Tests and Diagnostics
When a defective is detected in the test, following typical cause is considered.
Checking the connection, execute the subtest again.
Subtest03
Antenna check & communication test of 11b mode
Caution: To execute subtest 03-06, use another computer (with Calexico wireless LAN
card) that can communicate by the wireless LAN as a responder machine to
perform those tests. Access points are also required. (Access point for 802.11a,
802.11b and 802.11g )
Be sure to turn the wireless communication switch ON before executing wireless
LAN communication test. (The wireless communication LED lights orange.)
Release the write-protection of floppy disk for the test.
Setting the responder machine
Connect the responder machine to the access points (for 802.11a, 802.11b and 802.11g) with a
cross cable and turn on the access points.
Insert the floppy disk containing the wireless LAN test program into the FDD of the responder
machine and turn on the responder machine.
This subtest checks the connection and communication of wireless LAN antenna of
Calexico 802.11b mode.
After finishing the test, OK message will appear in the display. Press any key and
return to the test menu.
When a defective is found during the test, NG message will appear in the display.
Press any key and following message will appear in the display. Check which
antenna (Main/Aux) is defective.
*************************************************************
*
*
*
*************************************************************
Press any key and return to the test menu.
3-60
3.26 Wireless LAN Test Program (Intel-made Calexico2 a/g)
? Connection of wireless LAN card
? Defective wireless LAN card
? Disappearance of MAC address data
Aux Antenna Test : NG !!
TECRA M3 Maintenance Manual (960-507)
*
*
*