Page Edge Filler (Adf) - Fujitsu FI-5900C Operator's Manual
Image scanner
Hide thumbs
Also See for FI-5900C:
- Operator's manual (257 pages) ,
- Getting started (30 pages) ,
- Consumable replacement and cleaning instructions (24 pages)
Table of Contents
Advertisement
8.6 Page Edge Filler (ADF)
Depending on the state of the documents, the shadow of the scanned document appears in the end portion
of the output image and black thin lines may be generated.
If this is the case, you can improve the output image by using the "Page Edge Filler" function. This func-
tion fills the end portion of the image so that it looks clean.
Configure the settings for the Page Edge Filler as follows:
1.
Start up the Software Operation Panel.
Refer to
"8.1 Scanner Settings" on page
2.
Select [Device Setting 2] from left side list in the window, and select
[Paper Edge Filter (ADF)] from its lower level.
3.
Specify the length for each end section; top, bottom, right, and left, to fill
the end sections.
L
170.
T
T : Top edge = 0 ~ 15 mm
D : Bottom edge = -7 ~ 7 mm
R : Right edge = 0 ~ 15 mm
Generated
L : Left edge = 0 ~ 15 mm
R
(can be set in increments of 1mm)
image
Filled area
D
8.6 Page Edge Filler (ADF)
8
185
Advertisement
Table of Contents
