Table of Contents
Advertisement
INSTAllATION
n Mobile Installation
1 Clean and dry the installation location.
Do not install the bracket close to an air bag.
2 Remove the release paper from the base
of the panel bracket, then secure it in
place using the 3 supplied self-tapping
screws.
• Allow the panel to set for a while, to ensure
it remains fast. Otherwise, vibrations may
occur.
• After removing the release paper, it cannot
be reused.
3 Attach the panel holder to the panel
bracket using the 2 supplied SEMS
screws.
4 Attach the RC-D70 to the panel holder
so that it locks in place.
n Fixed Station
1 Attach the panel holder to the base
stand using the 2 supplied SEMS
screws.
2 Attach the RC-D70 to the panel
holder so that it locks in place.
2
Adhesive tape
Panel holder
Panel holder
Tapping screw
(4 mm x 2 mm)
Flat washer
Panel
bracket
SEMS screw
(M4 x 0 mm)
SEMS screw (M4
x 0 mm)
Base stand
Advertisement
Table of Contents
