Table of Contents
Advertisement
9. UNIT WIRING DIAGRAM
AVC Unit
9.1.
POWER Board
EFP2
EFP1
PFP2
PFP1
PSC
CONTROL Board
Note:
Before fixing the CONTROL Board,
PSC connector should be inserted
nto the board
Lead clamp for EFP1, EFP2,
ESC and EARTH should be locked
after fixing EARTH and looped
EFP1, EFP2 and ESC wires
AV3000 AVC Unit Service Manual
P001P
ESF
PSF
P002P
EFP1
EFP2
P003P
ESC
PSP
PSP
ESC
EARTH
EFP1, EFP2, ESC and
Terminals of EARTH wire should be fixed with
EARTH should never
two screws, one for the POWER Board and the
be bunched together
other for the front key
with ZSC (Nittoh
adhesive tape
No. 188
Preparation:
L=50mm)
EARTH wire should be wrapped
& soldered with two 1P-terminals
10
AV Board
ESC
PL702
Lead clamp for EFP1, EFP2 and ESC
should be locked after fixing EFP1
and EFP2 and looped wires
Note:
Make sure the loop is held down
so that it is not pinched by the
top cover
10
150
36
Specification
1. This Drawing shows the wire dressing and connection of
the AVC3-E Final Assembly.
2. Connectors with wire should be inserted into plug pin
posts as shown on the table below:
Plug Pin 1
Plug Pin 2
Connectors with wire
Name Assembly list
Board
Name Board
ESC
FINAL Assembly
CONTROL Brd PSC
AV Board PL702
EFP1 FINAL Assembly
POWER Board PFP1 HCP111
EFP2 FINAL Assembly
POWER Board PFP2 HCP111
ESF
FINAL Assembly
AV Board
PSF
HCP111
PSP
POWER Board
AV Board
PSP
-
3. For plug pin posts with lock function, connector housings
should be inserted deep enough so that it can be locked.
4. For plug pin posts without lock function, connector housings
should be inserted as deeply as possible.
5. Flexible flat cable ESF should be fixed as shown on the
drawing below:
ESF
HCP111
Printing
side
Insert into the
deepest position
and lock
Name
P002P
P003P
P001
-
PSF
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
