Dos-Control Sipdip - Dell Networking 2024 Reference Manual
Hide thumbs
Also See for Networking 2024:
- System information manual (273 pages) ,
- User manual (46 pages) ,
- System information manual (146 pages)
Table of Contents
Advertisement
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example activates L4 Port Denial of Service protection.
console(config)#dos-control l4port
dos-control sipdip
Use the dos-control sipdip command in Global Configuration mode to
enable Source IP Address = Destination IP Address (SIP=DIP) Denial of
Service protection. If the mode is enabled, Denial of Service prevention is
active for this type of attack. If packets ingress with SIP=DIP , the packets is
dropped if the mode is enabled.
Syntax
dos-control sipdip
no dos-control sipdip
Default Configuration
Denial of Service is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example activates SIP=DIP Denial of Service protection.
console(config)#dos-control sipdip
1481
Denial of Service Commands
Advertisement
Chapters
Table of Contents
