Related Manuals for Makita 6096D
Summary of Contents for Makita 6096D
- Page 1 INSTRUCTION MANUAL Cordless Driver Drill 6096D 001717 WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
The noise level under working may exceed 80 dB(A) manufacturer declare that the following Makita Wear ear protection machine(s): Designation of Machine: Cordless Driver Drill Model No./ Type: 6096D are of series production and Conforms to the following European Directives: 98/37/EC until 28th December 2009 and then with... -
Page 3: General Power Tool Safety Warnings
2006/42/EC from 29th December 2009 Do not expose power tools to rain or wet And are manufactured in accordance with the following conditions. Water entering a power tool will standards or standardised documents: increase the risk of electric shock. EN60745 Do not abuse the cord. -
Page 4: Specific Safety Rules
power tool will do the job better and safer at the parts. This will ensure that the safety of the power rate for which it was designed. tool is maintained. 18. Do not use the power tool if the switch does 29. -
Page 5: Functional Description
FUNCTIONAL DESCRIPTION using battery. Do not disassemble battery cartridge. If operating time has become excessively CAUTION: shorter, stop operating immediately. It may Always be sure that the tool is switched off and the • result in a risk of overheating, possible burns battery cartridge is removed before adjusting or and even an explosion. -
Page 6: Reversing Switch Action
Reversing switch action Adjusting the fastening torque 1. Reversing 1. Adjusting ring switch trigger 2. Drill marking 3. Pointer 001721 001723 This tool has a reversing switch to change the direction The fastening torque can be adjusted in 17 steps by of rotation. -
Page 7: Maintenance
counterclockwise. Use a cutting lubricant when drilling metals. The exceptions are iron and brass which should be drilled OPERATION dry. Screwdriving operation CAUTION: Pressing excessively on the tool will not speed up • the drilling. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool. - Page 8 Makita Corporation Anjo, Aichi, Japan 884181E222...