Page 1
ORDER NO. CRT3058 LS430 AUDIO SYSTEM POWER AMPLIFIER VEHICLE DESTINATION PRODUCED AFTER TOYOTA PART No. ID No. PIONEER MODEL No. LEXUS LS430 Europe, Middle Near East, August 2003 86280-50320 GM-8537ZT/WL Australia, North America 86280-50330 GM-8537ZT-91/WL General Area Manufactured for TOYOTA...
For details, refer to "Important symbols for good services". GM-8537ZT/WL GM-8537ZT-91/WL - Supplementally model is identical to the original except for the addition of following items. *: Non Spare Part Part No. Description GM-8537ZT-91/WL Cover CEG1045(x2) Polyethylene Bag CEG1174 * Air Cap...
Backup current ... .0.3mA or less Dimensions(No Bracket) ..285mm(W)x51mm(H)x128mm(D) Weight(No Bracket) ..1.6kg Maximum output power ..39W or more(Front) 13W or more(Tweeter) 21W or more(Rear) 35W or more(Woofer) GM-8537ZT/WL...
Guide page Detailed page ASL UNIT AUDIO INPUT DIFFERENTIAL OPERATIONAL AMPLIFIER CD:+8.2dBs (1kHz 0dB) OUTPUT OFFSET INDICATION AMP UNIT OUTPUT OFFSET INDICATION AMP INPUT GAIN ADJUSTMENT OUTPUT OFFSET INDICATION SIGNAL INPUT OFF CIRCUIT A B C TO SUDDEN DECREASE VOLTAGE GM-8537ZT/WL...
Page 9
Decimal points for resistor No differentiation is made between chip resistors and and capacitor fixed values discrete resistors. are expressed as : ← Symbol indicates a capacitor. ← No differentiation is made between chip capacitors and 0.022 R022 discrete capacitors. GM-8537ZT/WL...
1.The parts mounted on this PCB include all necessary parts for several destination. For further information for respective destinations, be sure to check with the schematic dia- gram. 2.Viewpoint of PCB diagrams Capacitor Connector SIDE A DSP UNIT SIDE B Chip Part P.C.Board CN906 GM-8537ZT/WL...
6. ADJUSTMENT - Jigs When attaching the DSP unit to the AMP unit, use "Jigs" (GGD1245). GGD1245 GM-8537ZT/WL...
Page 29
- Connection Diagram FX-MG9187ZT/EW(Pioneer AMP Model) FX-MG9687ZT/EW(Marklevinson AMP Model) FX-MG9087ZT/EW(Pioneer AMP Model) FX-MG9587ZT/EW(Marklevinson AMP Model) CD-R8137ZT/E GEX-T8037ZT/EW AM/FM TUNER REAR CON. HEAD UNIT Non-connected Non-connected For Head unit For Rear con. GGD1339 Bullet connector (ACC,+B, GM-8537ZT/WL ILL,GND) Marklevinson AMP NAVI...
Page 30
- Connection Diagram FX-MG9187ZT/Q1(Pioneer AMP Model) CD-R8137ZT/E GEX-T8137ZT/Q1 FX-MG9687ZT/Q1(Marklevinson AMP Model) AM/FM TUNER REAR CON. HEAD UNIT Non-connected Non-connected For Head unit For Rear con. GGD1339 Bullet connector (ACC,+B, GM-8537ZT/WL ILL,GND) Marklevinson AMP NAVI AUI+ AUO+ To front right SP...
Page 31
- Connection Diagram FX-MG9187ZT/UC(Pioneer AMP Model) FX-MG9687ZT/UC(Marklevinson AMP Model) CD-R8137ZT/E GEX-T8137ZT/UC AM/FM TUNER REAR CON. HEAD UNIT Non-connected Non-connected For Head unit For Rear con. GGD1339 Bullet connector (ACC,+B, GM-8537ZT/WL ILL,GND) Marklevinson AMP NAVI ECU AUI+ AUO+ To front right SP...
Removing the Bracket (Fig.2) Remove the three screws and then remove the Bracket. Removing the DSP Unit (Fig.2) Straighten the tabs at seven locations indicated. Remove the four screws and then remove the DSP Unit and the Bracket Shield together. Fig.2 GM-8537ZT/WL...
Page 36
2 Now one of the 18-pin connectors gets disconnected from the DSP Unit by doing 1 so that it becomes easier to detach the DSP Unit. Lift and remove the DSP Unit and the Shield together. Be careful not to give any stress to the 18-pin connectors on both sides when removing the DSP Unit and the Shield. GM-8537ZT/WL...
Page 37
- " Pawl bending and soldering " points of the pawls for securing the base plate of a shielded case (bot- tom case). The portion marked by is a point in which pawl bending and soldering are necessary. DSP UNIT GM-8537ZT/WL...
The 19 pin (DSPCHIP) waveform 1 The waveform to indicate that IC301 is defective (No information about IC311) Low(0V) Hi(5V) 2 The waveform to indicate that IC311 is defective Low(0V) Hi(5V) - The 67 pin (drst) waveform during normal DSP operation Low(0V) GM-8537ZT/WL...
Page 40
SIDE A DSP UNIT CN102 CN101 19pin DSPCHIP IC101 67pin drst GM-8537ZT/WL...
Page 41
ASL noise input AVSS GND for microcomputer AD SMUTE Codec soft mute output VREF Reference input for microcomputer AD AVCC Power supply for microcomputer AD DSPIN1 DSP 1 I/F serial data input DSPOUT1 DSP 1 I/F serial data output GM-8537ZT/WL...
Page 42
I/O7 NJM4580MD I/O6 I/O5 A0-A16 :Address input I/O4 :Chip enable input A OUTPUT :Output enable input I/O3 :Write enable input I/O0-I/O7 :Input / Output A -INPUT B OUTPUT :Power I/O2 :GND I/O1 A +INPUT B -INPUT I/O0 B +INPUT GM-8537ZT/WL...
Page 43
Outside RAM : Address output pin DVDD Digital : Power supply pin (5V or 3.3V) DVSS Digital : GND pin (0V) Outside RAM : Output enable pin 57-64 IO0-7 Outside RAM : Data input / output pin * AK7706VTA GM-8537ZT/WL...
Page 44
DIF0/CSN Audio interface format 0 pin / Chip select pin DIF1/CCLK Audio interface format 1 pin / Control data clock pin LOOP0/CDTI Loop back mode 0 pin / Control data input pin TDM I/F format mode pin * AK4529XQ GM-8537ZT/WL...
• BEEP output available • BEEP output available <<JUDGMENT>> DSP error DSP error confirmation • communication error:Serial IF Error retry • DSP reset(Pin 67) | About 1 second Normal operation <<JUDGMENT>> ACC/Back up ON/OFF ACC ON/Back up ON Main loop GM-8537ZT/WL...
8. OPERATIONS There is no information to be shown in this chapter. GM-8537ZT/WL...
Page 50
PIONEER ELECTRONICS (USA) INC. P.O.Box 1760, Long Beach, CA 90801-1760 U.S.A. PIONEER EUROPE NV Haven 1087 Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE.LTD. 253 Alexandra Road, #04-01, Singapore 159936 C PIONEER CORPORATION 2003 K-ZZB. JULY 2003 Printed in Japan...