Table of Contents
Advertisement
4. The fan assembly is made up of two pieces, an air baffle and the fan.
5. Release the fan by pressing the two plastic tabs 3 as shown. Slide the fan
6. Position the new fan in the rotating bay assembly and snap it into place.
7. Position the new air baffle in the rotating bay assembly and snap it into place.
8. Reconnect the fan cable to the system board connector.
9. To complete the installation, go to "Closing the cover and connecting cables."
Closing the cover and connecting cables
After replacing FRUs, you need to install any removed parts, replace the cover, and
reconnect any cables, including telephone lines and power cords.
1. Ensure that all components have been reassembled correctly and that no tools
2. Lower the drive bay assembly to the normal position.
3. Clear any cables that might impede the replacement of the cover.
4. Position the cover over the chassis and pivot it down over the computer until it
Release the air baffle by pressing the plastic tab 1 as shown, then remove the
air baffle from the inside of the rotating bay assembly.
downward until the retaining tabs 2 are released, then remove the fan from
the inside of the rotating bay assembly.
or loose screws are left inside your computer.
snaps into place.
Chapter 8. Replacing FRUs (Types 8095, 8141, 8142, 8145, 8420, and 8421)
113
Hide quick links:
Advertisement
Table of Contents
