Table of Contents
Advertisement
1.
Choose a day when the wind is light.
antenna should be blowing slightly (not greater than 30 degrees) and not be blowing
straight out. Find a wide-open field.
2.
turn on the Radio transmitter. to avoid interference, always turn on the trans-
mitter before turning on the Airplane. turn on the airplane.
3.
Two people should work together to hand launch the Airplane. One should control the
Remote Control and one will launch the Airplane.
4.
Face the Airplane into the wind. Move the left hand control stick all the way up. Then
the person should carefully keep their hands away from the propeller while pressing
the red button
*
5.
With the Airplane tilted at about 10 degrees, propel and release it into the wind.
6.
Let the Airplane climb to and fly at about 50 to 300 feet.
7.
To steer the Airplane, move the Control Stick (Functions 1 and 2) to the left to steer to
the left, and right to steer it right. Move the elevator and rudder trims slightly to adjust
for minor changes in direction and tilt of the Airplane.
note: Letting go of the Control Sticks will automatically bring them to a center position.
This will cause the Airplane to resume normal flight if the trims are adjusted properly.
8.
Normal flight time for one full charge is about 20-30 minutes. When the battery begins
to reach the end of its power, the red LED light on the Transmitter will light up, indicat-
ing low transmitter power. When this occurs, IMMEDIATELY LAND THE AIRPLANE.
Important: If damage is caused due to a crash; your warranty is void.
9.
To bring in the Airplane for landing, glide the Airplane down against the wind. Move
the left Control Stick toward the center to slow the Propellers. Move the right Control
Stick to adjust for direction. Continue to decrease the Propeller speed and direction
until you bring them to a stop and land the Airplane.
10.
Turn OFF the Airplane and then turn OFF the Transmitter.
InSPectIon, mAIntenAnce And cleAnIng
1.
Inspection, maintenance, and cleaning should be performed only by an adult. Turn off
the Airplane and Transmitter before inspection, adjustment, maintenance or cleaning.
2.
Do not use solvents or liquid cleaners to clean the Airplane. Use of solvents or liquid
cleaners will damage the material. Use only a dry, soft cloth for cleaning.
3.
Before each use check for loose screws, misalignment or binding of moving parts,
cracked or broken parts, damaged housing, damaged wiring, loose wheels and any
other condition that may affect its safe operation. do not use a damaged Airplane.
*
The red button is a safety device to prevent the plane from starting accidentally. It must be pushed before the propel-
ler can start.
SKU 94774
FlYIng the AIRPlAne
on the airplane. The motor should now be is running at full power.
For technical questions please call 1-800-444-3353.
The Ribbon (17) attached to the Transmitter
ReV 07a
Page 7
Advertisement
Table of Contents
