Toshiba e-STUDIO2820C Service Handbook page 132
Multifunctional digital color systems
Hide thumbs
Also See for e-STUDIO2820C:
- Service manual (1246 pages) ,
- Service handbook (546 pages) ,
- Management manual (226 pages)
Table of Contents
Advertisement
Determine each setting value with S-ACS level coefficients.
17 or less
Setting value
"1"
When the default setting of color
modes is [Black] or [Full Color]
* Note: S-ACS level coefficients are only a reference and therefore they are acceptable if they fall within
[E] Precautions for setting
•
When documents including a large amount of color pages are printed, set a smaller value for
<(08)9934> (S-ACS operation setting) so that the performance level and the consumption level of
supplies will be maintained in a better balance. However, when the documents to be printed include
more black pages, such as when MCV is 5k or more, the consumption of supplies related to Y, M
and C will increase because printing will be performed mostly in the "Color mode".
•
When documents including a large amount of black pages are printed, set a larger value for
<(08)9934> (S-ACS operation setting) so that the consumption level of the supplies related to Y, M
and C will be lower. However, when the documents to be printed include more color and black
pages, the performance may not be affected.
•
When the printing tendency of the user has changed significantly (e.g. Color rate changed from 80%
to 20%), the performance level or the consumption level of the supplies may also change. In this
case, check these levels after a specific period so that the most appropriate setting values can be
determined.
•
The number of outputs in [Auto Color] are counted as follows:
Color outputs: Counted as color
Black outputs: Counted as black
•
When the "Color mode" is [Auto Color], black pages are printed only with toner K and thus only the
toner K is consumed.
e-STUDIO2820C/2830C/3520C/3530C/4520C
SELF-DIAGNOSTIC MODE
S-ACS operations setting
S-ACS level
coefficient *
17 to less
than 23
Setting value
"2"
Fig. 2-12
23 or less
MCV
less than 5k
When the default setting of color
modes is [Auto Color]
© 2008 TOSHIBA TEC CORPORATION All rights reserved
2 - 106
5k or more
Setting value
"9"
3.
- Quick Links:
- Setting Mode (08)
Hide quick links:
Advertisement
Table of Contents
