DMR-ES10P / DMR-ES10PC CONTENTS Page Page 1 Safety precautions 13.1. After replacing the RAM Drive with new one 1.1. General guidelines 13.2. When the unit does not operate normally after replacing 1.2. Caution for fuse replacement the Timer Microprocessor or Main P.C.B.
DMR-ES10P / DMR-ES10PC 1 Safety precautions 1.1. General guidelines 1. When servicing, observe the original lead dress. If a short circuit is found, replace all parts which have been overheated or damaged by the short circuit. 2. After servicing, see to it that all the protective devices such as insulation barriers, insulation papers shields are properly installed.
DMR-ES10P / DMR-ES10PC 2 Prevention of Electrostatic Discharge (ESD) to Electrostatic Sensitive (ES) Devices Some semiconductor (solid state) devices can be damaged easily by static electricity. Such components commonly are called Electrostatic Sensitive (ES) Devices. Examples of typical ES devices are integrated circuits and some field-effect transistor-sand semiconductor "chip"...
DMR-ES10P / DMR-ES10PC 3 Precaution of Laser Diode 4 Handling the Lead-free Solder 4.1. About lead free solder (PbF) Distinction of PbF P.C.B.: P.C.B.s (manufactured) using lead free solder will have a PbF stamp on the P.C.B. Caution: · Pb free solder has a higher melting point than standard solder; Typically the melting point is 50 - 70°F (30 - 40°C) higher.
DMR-ES10P / DMR-ES10PC 6 New Feature 6.1. Quick start function(REC) 1. General A few seconds after tuning on the unit,you can start recording to DVD-RAM,HDD. You can switch the operation of this function (ON/OFF) on the menu screen. . 2. Quick start(REC) principle In the power-off at Quick start, only power supplies for video IC,tuner and storage media are cut off.
DMR-ES10P / DMR-ES10PC 7 Taking out the Disc from RAM-Drive Unit when the Disc cannot be ejected by OPEN/CLOSE button 7.1. Forcible Disc Eject 7.1.1. When the power can be turned off. 1. Turn off the power and press [STOP] [CH UP] keys on the front panel simultaneously for 5 seconds.
DMR-ES10P / DMR-ES10PC 8 Service Explorer Confirm “RAM-Drive Last Error” in Service Mode Execute Service Mode 1. Press [REC], [CH UP] and [OPEN/CLOSE] simultaneously for 5 seconds when P-off. FL Display: *After finishing display “(7). Factor of Drive Error occurring”, press [0] [2] ~[1] [9] keys of the Remote Controller so that 19 memories can be displayed as maximum.
Page 11
DMR-ES10P / DMR-ES10PC (5) Error occurring Disc type is displayed for 5 seconds. (6) Disc Maker´s ID is displayed for 5 seconds. Example of Disc Maker´s ID: DVD-R Disc FL Display (Disc Maker´s ID) Disc Maker Country Panasonic Japan Pioneer...
DMR-ES10P / DMR-ES10PC 9 Self-Diagnosis and Special Mode Setting 9.1. Self-Diagnosis Functions Self-Diagnosis Function provides information for errors to service personnel by “Self-Diagnosis Display” when any error has occurred. U**, H** and F** are stored in memory and held. You can check latest error code by transmitting [0] [1] of Remote Controller in Service Mode.
DMR-ES10P / DMR-ES10PC 9.2. Special Modes Setting Item FL display Key operation Mode name Description Front Key TEST Mode *All the main unit´s parameters (include tuner) Press [STOP], are initialized. [OPEN/CLOSE] keys simultaneously for five seconds when power is off.
Page 15
DMR-ES10P / DMR-ES10PC Item FL display Key operation Mode name Description Front Key Demonstration Ejection of the disc is prohibited. *When lock the tray. When the power is on, press lock/unlock The lock setting is effective until unlocking the [STOP]...
DMR-ES10P / DMR-ES10PC 9.3. Service Modes Service mode setting: While the power is off, press REC, CH UP and OPEN / CLOSE simultaneously for five seconds. Item FL display Key operation Mode name Description (Remote controller key) Release Items Item of Service Mode executing is cancelled.
Page 17
DMR-ES10P / DMR-ES10PC Item FL display Key operation Mode name Description (Remote controller key) Audio Mute (XTMUTE) Check whether mute is applied normally by Press [2] [1] in service mode. the timer microprocessor. Audio Mute (XDMUTE) Check whether mute is applied normally by Press [2] [2] in service mode.
Page 18
DMR-ES10P / DMR-ES10PC Item FL display Key operation Mode name Description (Remote controller key) Turn on all FL/LEDs All segments of FL and all LEDs are turned All segments are turned on. Press [5] [1] in service mode. S1 signal output Forcibly superimpose the S1 signal (approx.
DMR-ES10P / DMR-ES10PC 10 Assembling and Disassembling 10.1. Disassembly Flow Chart The following chart is the procedure for disassembling the casing and inside parts for internal inspection when carrying out the servicing. To assemble the unit, reverse the steps shown in the chart below.
DMR-ES10P / DMR-ES10PC 10.3. Top Cover 10.5. Digital P.C.B. 1. Remove the 2 screws (A) and 3 screws (B). 1. Remove FFC and a Screw (A). 2. Slide Top Cover rearward and open the both ends at rear 2. Lift up Digital P.C.B. slightly so to disconnect Connector to side of the Top Cover a little and lift the Top Cover in the remove Digital P.C.B.
DMR-ES10P / DMR-ES10PC 10.6. DVD-RAM Drive 2. Remove 2 Screws (B) and disconnect Connector (A) to 1. Remove 3 Screws (A) to remove DVD-RAM Drive. remove Power P.C.B. 2. Lift up DVD-RAM Drive slightly and remove FFC and remove Cable between DVD-RAM Drive and Main P.C.B.
DMR-ES10P / DMR-ES10PC 10.9. Front (L) P.C.B. 1. Remove a Screw (A) to remove Front (L) P.C.B. 10.10. Main P.C.B. 1. Disconnect Connector (A) for Front (L) P.C.B. 2. Remove 9 Screws (A),.2 Screws (B) 3. Remove Power P.C.B. Angle, Digital P.C.B. Angle and Front Shield Unit, and disconnect Connector (A) to remove Main P.C.B.
DMR-ES10P / DMR-ES10PC 11 Service Fixture and Tools Part Number Description Compatibility RFKZ0125 Extension FFC (Digital P.C.B. - DVD-RAM Drive / 40 Pin) Same as E50/ E55 series RFKZ0126 Extension Cable (MainP.C.B. - DVD-RAM Drive/ 4 Pin) Same as E30/HS2 series RFKZ0216 Extension Cable (MainP.C.B.
Perform auto recording and playback for one minute using the RAM No abnormality should be seen in the picture, sound or operation. disc. *Panasonic DVD-RAM disc should be used when recording and playback. If a problem is caused by a VCD, DVD-R, DVD-Video, Audio-CD, or No abnormality should be seen in the picture, sound or operation.
DMR-ES10P / DMR-ES10PC 15 Voltage and Waveform Chart Note) Circuit voltage and waveform described herein shall be regarded as reference information when probing defect point, because it may differ from an actual measuring value due to difference of Measuring instrument and its measuring condition and product itself.
DMR-ES10P / DMR-ES10PC 17.2. Analog Video Block Diagram IC3001 :REC SIGNAL :PB SIGNAL (VIDEO PROCESSOR) DVD C IN P9001 P7401 COUT DM BIAS 6M LPF JK3902 A/V OUT C75 OUT JACK CPN C OUT DVD Y IN P9001 P7401 YOUT DM...
DMR-ES10P / DMR-ES10PC 18.3. Sub Power Section (Main P.C.B. (1/5)) Schematic Diagram (P) TO P1102 TO P1102 POWER P.C.B. POWER P.C.B. P1501 P1501 LB1504 J0JKB0000003 X SW 5.8V X SW 5.8V X SW 5.8V X SW 5.8V X SW 5.8V...
DMR-ES10P / DMR-ES10PC 18.5. Video I/O Section (Main P.C.B. (3/5)) Schematic Diagram (V) AUDIO VIDEO AUDIO VIDEO LINE LINE LINE LINE LINE IN(R) IN(R) IN(L) IN(L) L3 IN L1 IN CPN L3 IN CPN L1 IN OUT2(R) OUT2(L) OUT V2...
Page 46
DMR-ES10P / DMR-ES10PC JK3903 K1U407B00004 PR/CR PB/CB DIGITAL (RED) (BLUE) (GREEN) AUDIO OUT COMPONENT VIDEO OUT (480P/480I) R4901 0 R4903 0 IECOUT C4906 C4904 C4903 6V47 P:Sub Power Section(Page: M:Main Net Section(Page: R3923 R3924 R3925 V:Video I/O Section(Page: A:Audio Main Section(Page:...
DMR-ES10P / DMR-ES10PC 21 Replacement Parts List Notes: Ref. Part No. Part Name & Remarks Description *Important safety notice: RFKNVXY1867 RAM DRIVE UNIT (RTL)(SPC) Components identified mark have special RMV0302 BARRIER (SPC) RMX0323 PCB SPACER characteristics important for safety. RMX0298...
Page 62
DMR-ES10P / DMR-ES10PC Ref. Part No. Part Name & Remarks Ref. Part No. Part Name & Remarks Description Description C3028 F2A0J470A245 6.3V 47U C7520 ECJ1VC1H220J 50V 22P C3029 F2A0J471A247 6.3V 470U C7521,2 ECJ1VC1H180J 50V 18P C3030 F2A0J470A245 6.3V 47U C7523...
Page 63
DMR-ES10P / DMR-ES10PC Ref. Part No. Part Name & Remarks Ref. Part No. Part Name & Remarks Description Description K7502- ERJ3GEY0R00V 1/10W 0 R3032,3 ERJ3GEYJ103V 1/10W 10K K7509 ERJ3GEY0R00V 1/10W 0 R3036 ERJ3GEYJ103V 1/10W 10K K7511 ERJ3GEY0R00V 1/10W 0 R3039,4...
Page 64
DMR-ES10P / DMR-ES10PC Ref. Part No. Part Name & Remarks Ref. Part No. Part Name & Remarks Description Description R7522,2 ERJ3GEYJ101V 1/10W 100 X7501 H0A327200108 CRYSTAL OSCILLATOR R7524 ERJ3GEYJ472V 1/10W 4.7K X7502 H0D100500018 CRYSTAL OSCILLATOR R7525 ERJ3GEY0R00V 1/10W 0 R7526 ERJ3GEYJ332V 1/10W 3.3K...
Page 65
DMR-ES10P / DMR-ES10PC Ref. Part No. Part Name & Remarks Ref. Part No. Part Name & Remarks Description Description W513-15 ERJ6GEY0R00V 1/8W 0 L1400 G0A220GA0026 COIL 22UH W516 ERJ3GEY0R00V 1/10W 0 L1401,0 G0A220ZA0041 COIL 22UH W517,18 ERJ6GEY0R00V 1/8W 0 L1403...
Page 66
DMR-ES10P / DMR-ES10PC Ref. Part No. Part Name & Remarks Description S7001 EVQPC105K SWITCH,POWER...