10. ENERGY EFFICIENCY....................17 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
Do not store items on the cooking surfaces. • Metallic objects such as knives, forks, spoons and lids • should not be placed on the hob surface since they can get hot. Do not use a steam cleaner to clean the appliance.
ENGLISH • Protect the bottom of the appliance mains cable. Contact our Authorised from steam and moisture. Service Centre or an electrician to • Do not install the appliance adjacent change a damaged mains cable. to a door or under a window. This •...
Page 6
• Remove all the packaging, labelling • Cookware made of cast iron, and protective film (if applicable) aluminium or with a damaged bottom before first use. can cause scratches on the glass / • Use this appliance in a household glass ceramic.
ENGLISH • Do not clean the burners in the • Disconnect the appliance from the dishwasher. mains supply. • Cut off the mains cable and discard it. 2.6 Disposal • Flat the external gas pipes. 2.7 Service WARNING! Risk of injury or suffocation. •...
Page 8
4.1 Burner overview 1. Push the control knob down and turn it counterclockwise to the maximum gas supply position ( 2. Keep the control knob pushed for equal or less than 10 seconds. This lets the thermocouple warm up. If not, the gas supply is interrupted.
ENGLISH 4.3 Turning the burner off To put the flame out, turn the knob to the off position WARNING! Always turn the flame down or switch it off before you remove the pans from the burner. When you refit the grate of 4.4 Using the wok stand the Triple Crown burner, make sure to match the...
6. CARE AND CLEANING remove stubborn stains with a paste WARNING! cleaner. Refer to Safety chapters. 3. After you clean the pan supports, make sure that they are in correct 6.1 General information positions. 4. For the burner to operate correctly, •...
ENGLISH 7.1 What to do if... Problem Possible cause Remedy There is no spark when you The hob is not connected to Check if the hob is correctly try to activate the spark gen- an electrical supply or it is connected to the electrical erator.
7.3 Labels supplied with the accessories bag Stick the adhesive labels as indicated below: MOD. MOD. MOD. TYPE PROD.NO. IP20 PROD.NO. PROD.NO. SER.NO. 0049 SER.NO SER.NO 03 IT DATA DATA MADE IN ITALY A) Stick it on Guarantee Card and send C) Stick it on instruction booklet.
Page 13
ENGLISH However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m³ and 11 m³. If there are other fuel burning appliances in the same room, B.S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements.
8.4 Injectors replacement WARNING! Make sure the flame does 1. Remove the pan supports. not go out when you quickly 2. Remove the caps and crowns of the turn the knob from the burner. maximum position to the 3. With a socket spanner 7 remove the minimum position.
Page 15
ENGLISH 8.7 Replacement of the Before carrying out the connection, make sure: connection cable 1. The limiter valve and the electrical The replacement of electric system can take the appliance load cable must be carried out (see the rating plate) exclusively by the service 2.
8.8 Building In A) supplied seal B) supplied brackets CAUTION! min. 600 mm Install the appliance only on a worktop with flat surface. min. 450 mm min. 650 mm 8.9 Possibilities for insertion min. 55 mm 30 mm The panel installed below the hob must...
ENGLISH 9.3 Other technical data Gas original: G20 (2H) 20 mbar = 10,5 kW TOTAL POWER: Gas replacement: G30 (3+) 28-30 mbar = 763 g/h G31 (3+) 37 mbar = 750 g/h Electric supply: 220-240 V ~ 50/60 Hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse Appliance category: II2H3+...
Left rear - Semi-rapid 54.4% Right rear - Semi-rapid 54.4% Energy efficiency per gas burner Centre Middle - Triple Crown 52.0% (EE gas burner) Left front - Semi-rapid 54.4% Right front - Auxiliary not applicable Energy efficiency for the gas hob 53.8%...