Page 1
ÖKO_FAVORIT 60850 U Dishwasher User Instructions Downloaded from DishWasher-Manual.com Manuals...
Page 2
Dear customer, Please read these user instructions carefully. Above all please observe the safety instructions on the first few pages ofthese user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance.
Operating instructions OPERATING INSTRUCTIONS Safety instructions The safety features of AEG electrical appliances comply with accepted technical standards and the German Appliance Safety Law. Neverthe- less, as a manufacturer we consider it our obligation to make you aware of the following safety information: Installation, connection and initial use •...
• If the mains cable for the appliance is damaged, it must be replaced with special cable (obtainable from AEG customer service) by an AEG authorised customer service centre. • Never unplug the appliance by pulling on the cable, always pull on the plug.
Operating instructions • The leak prevention system provides reliable protection from damage due to water leaks. For this system to function the following prereq- uisites must be met: – The appliance must remain connected to the mains even when it is switched off.
Operating instructions Economical and Ecological Dishwashing • Only connect the dishwasher to the hot water supply if your hot water is not electrically heated. • Ensure that the water softener is correctly adjusted. • Do not pre-rinse dishes under running water. •...
Operating instructions Appliance Features and Control Panel Top Spray Arm Rubber Seal for Connecting the Water Feed to the Middle Spray Spray Arms Container for Special Salt Container for Rinse Aid Container for Detergent Inlet Rating Plate Filters for Fan Assisted Drying Downloaded from DishWasher-Manual.com Manuals...
Operating instructions Control Panel Function Softener Door Button Button Handle Start Delay Indicators Multidisplay Control Panel Air Outlet for Fan Assisted Drying The Control Panel comprises the ON/OFF switch and the programme buttons with LED indicators. Softener and Function Button: in addition to the wash program marked, it is also possible to adjust the dishwasher's water softener using the combination of these buttons.
Operating instructions Prior to using for the first time Prior to using for the first time, remove all the clips with which the dish racks are secured for transport. Then perform the following steps: 1. Adjust the water softener 2. Filling with Special Salt for the Water Softener 3.
Operating instructions 1. The dishwasher must be switched off. 2. Press the INTENSIVE 70° and NORMAL 65° program buttons simultane- ously and keep pressed. 3. Press the ON/OFF switch. The LED indicators for the INTENSIVE 70° and NORMAL 65° program buttons flash. 4.
Page 13
Operating instructions 1. Open the door, remove the lower rack. 2. Undo the lid on the salt container by turning it anticlockwise. 3. Only when using for the first time: fill the salt container with water. 4. Place the funnel supplied on the container opening.
Operating instructions Filling with Rinse Aid Rinse aid ensures that your dishes gleam and are free from spots, and that you glasses are clear. Use only branded rinse aid for dishwashers. Never fill the rinse aid con- tainer with any another substance (e.g. concentrated vinegar). This would damage the appliance.
Operating instructions Adjusting Rinse Aid Dosing Rinse aid is added to the wash water from the container when the dishes are rinsed. The dose can be adjusted from 1-6, corresponding to 1-6 cm rinse aid. The dose is set to "4" in the factory. Only change the dose when streaks, milky spots or dried water drops are to be seen on glasses and dishes.
Operating instructions Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher For washing in the dishwasher the following cutlery/dishes are not suitable: are of limited suitability: • Cutlery with wooden, horn, •...
Operating instructions Loading Cutlery Long, pointed items of cutlery are a hazard if placed in the cutlery basket, particularly to children (see Safety Instructions). They should therefore be placed in the upper rack. Place knives, small spoons and small forks in the cutlery tray. Place forks and spoons that do not fit in the cutlery tray in the cutlery bas- ket.
Operating instructions If you use the grid insert, it is not possible to open the cutlery basket. To ensure that the cutlery basket cannot open on removal from the appliance, you should always hold both parts of the two part handle. 1.
Operating instructions 2. Fold the plate insert to the left. Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items.
Operating instructions Adjusting the Height of the Upper Rack Maximum Height of the Dishes in the Upper Rack Lower Rack With Raised Upper Rack 22 cm 31 cm With Lowered Upper Rack 24 cm 29 cm The height of the rack can also be adjusted when the rack is laden. Lowering the Upper Rack: 1.
Operating instructions Filling with Detergent Use only dishwasher detergent. Fill with Detergent: – Prior to the start of a wash programme (not for the Pre Wash pro- gramme). The detergent is released into the wash water during the programme. Please observe the manufacturer’s dosing and storage recommenda- tions given on the detergent packaging.
Operating instructions Bio Wash Programmes and Concentrated Detergents Based on their chemical composition, dishwasher detergents can be split into two basic types: – Conventional, alkaline detergents with caustic components – Weak alkaline concentrated detergents with natural enzymes. The use of BIO wash programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes;...
Operating instructions Selecting the Wash Programme (Programme Table) Choose the most suitable wash programme with the aid of this table: Coffee Type of Dinner Service and Cooking Utensils Service and Dishes Dessert Dishes with non-temperature resistant with delicate In Addition dishes glasses Type of...
Operating instructions Start the wash programme 1. Check that the dishes and cutlery are loaded into the dishwasher in such a manner that the spray arms are free to rotate. 2. Open the tap fully. 3. Shut the door. 4. Press the ON/OFF button. The ON/OFF button indicator illuminates. 5.
Operating instructions 1. Open the door of the dishwasher. The wash programme stops. 2. The indicator for the programme that is currently running extinguishes. 3. Close the door. The wash programme continues. Cancelling the wash programme 1. Press the button for the current wash programme and hold it pressed. The programme indicator for the current wash programme flashes for a few seconds and then extinguishes.
Operating instructions Switching Off the Dishwasher Only switch the dishwasher off when the multi-display indicates "0" remaining programme time. 1. Press the ON/OFF button. The ON/OFF button indicator extinguishes. Hot steam may escape from the appliance when opening the door immediately after the end of the programme.
Operating instructions Cleaning the Filter The filters in the base of the washing compartment are to a large extent self-cleaning. Nevertheless the filters should be checked and cleaned from time to time. Dirty filters will degrade the washing result. 1. Open the door, remove the lower rack.
Operating instructions What to do, when ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call in customer service to resolve one of the malfunctions listed here, or rectify an error made in the operation of the appliance, the customer service engineer’s visit is not free of charge, even during the period of guarantee.
Operating instructions ...problems occur during use of the dishwasher. Malfunction Possible Cause Remedy The door of the dishwasher is Shut the door. not closed properly. Mains plug is not plugged in. Insert mains plug. House fuse is defective. Replace fuse. The programme does Where dishes are to be not start.
Operating instructions The dishes are wet and dull. – Rinse aid was not used. – The rinse aid container is empty. There are streaks, milky spots or a bluish coating on glasses and dishes. – Lower rinse aid dosing. There are dried water drops on the glasses and dishes. –...
Operating instructions Notes for Test Institutes The salt container for the water softener and the rinse aid container must be completely full prior to the test. Test Standard: EN 5O 242 Comparative Programme: see "Program table; Test program" for full and half load Full Load: 12 place settings incl.
Installation and Connection Instructions INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted such that it is stable and level. • Using the spanner supplied, extend the threaded feet to compensate for unevenness in the floor and to adjust the height of the appliance to suit the surrounding units.
Installation and Connection Instructions If the facing panel is longer than 600 mm, the door of the appliance cannot be opened completely (the facing panel bumps against the plinth). If this is the case, the plinth must be cut out (see installation template) or the brace adapter for the extra long door BLT 60 must be used.
Page 34
Installation and Connection Instructions The plinth on free-standing appliances is not adjustable. • Free-standing appliances can be outfitted with a décor panel to match the facings of other kitchen equipment. The décor panels must be obtained from the kitchen man- ufacturer.
Installation and Connection Instructions Connecting the Dishwasher Water connection The dishwasher is fitted with safety devices that prevent the return of wash water into the drinking water system and comply with the appli- cable plumbing regulations. • The dishwasher can be connected to cold and hot water supplies up to max.
In the case that you wish to hang the drain hose in a wash basin, use a detachable hose elbow. You can obtain this from AEG customer service under spare part number ET 646 069 190. 1. Fit the elbow to the drain hose.
Installation and Connection Instructions Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the safety valve immediately interrupts the sup- ply of water to the appliance and the drain pump switches on.
Installation and Connection Instructions Connections The water inlet and drain hoses, as well as the mains cable must be con- nected beside the dishwasher because there is no space for them behind the appliance. The example plumbing and electrical installation given below can only be regarded as a recommendation;...
In diesen Ländern gelten die Garantiebedingungen der örtlichen Part- ner. Diese können dort eingesehen werden. Further after-sales service agencies overseas In these countries our AEG agents’ own guarantee conditions are appli- cable. Please obtain further details direct. Autres agences étrangères assurant le service après-vente Dans ces pays, les conditions de garantie des concessionnaires de la région sont valables.
Page 42
Downloaded from DishWasher-Manual.com Manuals...
Service SERVICE In the section "What to do, if..." the most important sources of faults that you can rectify yourself are summarised. If, nevertheless, you call in customer service to resolve a problem listed in these instruction, or because of an error made in operating the appliance, the customer service engineer’s visit is not free of charge, even during the warranty period.