Section 5- Troubleshooting - Electrolux EIGD55H Technical & Service Manual
Wave-touch & iq-touch
front-load dryer
Hide thumbs
Also See for EIGD55H:
- Technical & service manual (100 pages) ,
- Installation instructions manual (24 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
The following troubleshooting chart involves problems arising from improper drying techniques and are not valid
service issues. Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and
scum, and fabric damage. For satisfactory drying results, follow these suggestions provided by The Soap and
Detergent Association.
For Troubleshooting the electronic control and error codes, See Section Three Electronic Control.
Problem
Greasy, oily
stains
Lint
Pilling
(Fibers break
off, ball up and
cling to fabric.)
Shrinking
Wrinkling
Cause
1. Fabric softener sheet.
1. Overloading.
2. Overdrying causes static
electricity.
3. Lint screen not clean when
cycle began.
4. Lint is attached to "pills."
1. Overdrying.
1. Temperature too high.
2. Overdrying.
1. Overloading.
2. Leaving items in dryer after
cycle ends.
Correction
1. Rub fabric softener stains with bar soap.
Rinse and rewash.
2. Place fabric softener sheet on top of load
before starting the dryer.
3. Some "silk-like" fabrics should be air dried.
4. Add a few bath towels to small loads for
proper tumbling.
5. Use proper drying temperature.
1. Reduce load size and rewash using liquid
fabric softener in the final rinse.
2. Or, add a fabric softener sheet and tumble
without heat.
3. Use lint brush or roller to remove lint.
4. Check that lint filter is clean and in place.
1. Use a lint brush or shaver to remove pills.
2. Use fabric softener to lubricate fibers.
3. Turn items inside out to reduce abrasion.
4. When ironing, use spray starch or fabric
finish on collars and cuffs.
1. Irreversible condition.
2. Follow fabric care label directions.
3. If shrinking is a concern, check load often.
4. Remove items while slightly damp and hang
or lay flat to complete drying.
5. Block knits into shape.
1. Reduce load size and tumble at medium or
low heat for 5-10 minutes.
2. Remove items immediately. Hang or fold.
5-1
Troubleshooting
Hide quick links:
Advertisement
Table of Contents
