Connecting Microphones To The Audio In Connectors - Sony PXW-X500 Manual
Solid-state memory camcorder
Hide thumbs
Also See for PXW-X500:
- Service manual (184 pages) ,
- Operation manual (181 pages) ,
- Quick start manual (5 pages)
Table of Contents
Advertisement
On how to perform this operation, refer to the
operation manual for the microphone.
3
Plug the microphone cable into the MIC
IN connector, then set the AUDIO IN
switch for the channel on which you
want to record the audio from this
microphone to FRONT.
4
Secure the microphone cable with the
cable clamp.
Connecting Microphones to the
AUDIO IN Connectors
You can connect up to two monaural
microphones to the AUDIO IN CH-1/CH-2
connectors, using an optional CAC-12
Microphone Holder.
The following is the procedure for attaching an
electret condenser microphone such as the ECM-
674/678.
On how to attach the CAC-12, refer to the operation
manual for the CAC-12.
1
Attach the electret condenser
microphone.
1 Loosen the ball joint lock lever.
2 Wind the microphone spacer (sheet
type, supplied with the microphone)
around the microphone, while peeling
off the protective sheets on both sides
of the microphone spacer.
3 Place the microphone in the holder so
that "UP" is at the top.
4 Close the microphone holder.
5 Tighten the screw.
6 Position so that the microphone does
not interfere with the viewfinder and
tighten the ball joint lock lever.
39
Microphone
- Quick Links:
- Setting the Video Format
Hide quick links:
Advertisement
Table of Contents
