Connecting A Video Light; Using The Shoulder Strap - Sony PXW-X500 Manual
Solid-state memory camcorder
Hide thumbs
Also See for PXW-X500:
- Service manual (184 pages) ,
- Operation manual (181 pages) ,
- Quick start manual (5 pages)
Table of Contents
Advertisement
Connecting a Video
Light
With this camcorder, you can use the Anton
Bauer Ultralight 2 or equivalent video light
(powered by 12 V with maximum power
consumption of 50 W).
• If you connect the video light to the LIGHT
connector on the camcorder and set the LIGHT
switch to AUTO, you can turn the light on and
off automatically as you start and stop recording
on this camcorder.
• The output of the LIGHT connector on the
camcorder is regulated to 12 V even when the
camcorder is supplied with over 12 V power
(through the DC IN connector or battery pack).
The brightness or color temperature of the light
will not change in response to voltage increase.
Notes
• Do not connect video lights with power consumption
of 50 W or greater.
• The brightness or color temperature of the light will
change when the voltage (supplied through the DC IN
connector or from the battery pack) is less than 12 V.
To attach the video light
Fit the video light to the accessory shoe on the
camcorder grip, and connect the video light cable
to the LIGHT connector.
Note
The accessory shoe on the camcorder is of the
screw type. If you want to replace this with a slide-type
shoe, use the supplied cold shoe kit.
Using the Shoulder
Strap
To attach the shoulder strap
1
Fit one of the clips to a shoulder strap
fitting.
2
Fit the other clip to the shoulder strap
fitting on the other side of the grip in the
same way.
1
/
-inch
4
44
Pull up the strap to lock the fitting.
Clip
- Quick Links:
- Setting the Video Format
Hide quick links:
Advertisement
Table of Contents
