Sony bvm-l230 Operation Manual page 66
Hide thumbs
Also See for bvm-l230:
- Service manual (298 pages) ,
- Operation manual (96 pages) ,
- Brochure & specs (17 pages)
Table of Contents
Advertisement
Menu
H Delay
V Delay
External Sync
Comb
Aperture
Mono
Blue Only
R Off
66
Display Function Menu
Function and operation ([
Sets whether or not to display in H delay ([Off] or On).
When the 720/24, 25, 30P signal is input, the display position is changed with the PHASE
knob.
Note
The picture is not displayed in H delay in the following cases:
• When the input signal has no sync signal
• When the internal signal is displayed
• When Format of the Input Configuration menu is set to DVI Video or DVI Computer
• When Side by Side is set to On
• When Wipe is set to On
• When Butterfly is set to On
• When Blending is set to On
• When the captured frame is displayed
Sets whether or not to display in V delay ([Off] or On).
Note
The picture is not displayed in V delay in the following cases:
• When the input signal has no sync signal
• When the internal signal is displayed
• When Format of the Input Configuration menu is set to DVI Video or DVI Computer
• When Side by Side is set to On
• When Wipe is set to On
• When Butterfly is set to On
• When Blending is set to On
• When the captured frame is displayed
Sets whether or not to select external sync mode ([Off] or On) when the analog component
signal or analog RGB signal format is input.
When On is selected, the signal to be displayed is synchronized with the sync signal input to
the SYNC connector (External Sync).
When Off is selected, the signal to be displayed is synchronized with the sync signal included
in the signals being monitored (Internal Sync).
Notes
• When Component is set to YPbPr or RGB in Format of the Input Configuration menu, you
can set the external sync.
• The external sync is not set in the following cases:
– When the internal signal is displayed
– When the captured frame is displayed
Sets whether or not to use the comb filter (Off or [On]).
When Off is selected, the trap · band-pass filter (Trap/BPF) is selected.
You can select the type of comb filter in NTSC Comb Filter menu (page 58) of the Display
Setting menu.
Notes
• When Composite is set to Auto, NTSC, PAL or PAL-M in Format of the Input Configuration
menu, you can set the comb filter.
• The comb filter is not set in the following cases:
– When the internal signal is displayed
– When the captured frame is displayed
Sets whether or not to function the aperture modification (Off or On).
[Off] (when the signal is displayed in Aspect Correction mode of the native display), [On]
(when the signal is displayed in mode other than Aspect Correction of the native display)
Sets whether or not to display in monochrome mode ([Off] or On).
Note
When the displayed signal is XYZ, the signal is not displayed in monochrome mode.
Sets whether or not to display only the blue signal as a monochrome picture after cutting the
red and green signals ([Off] or On).
Note
When the displayed signal is XYZ, the signal is not displayed in blue only mode.
Sets whether or not to cut the red signal ([Off] or On).
Note
When the displayed signal is XYZ, the red signal is not cut.
]: factory setting)
Advertisement
Table of Contents
