General Information; Diagnosis; Test Mode - Pioneer DEH-P520 Service Manual
Multi-cd conrol high power cd player with rds tuner
Hide thumbs
Also See for DEH-P520:
- Operation manual (108 pages) ,
- Service manual (73 pages) ,
- Installation manual (40 pages)
Table of Contents
Advertisement
QQ
3 7 63 1515 0
7. GENERAL INFORMATION
7.1 DIAGNOSIS
7.1.1 TEST MODE
- Error Messages
If a CD is not operative or stopped during operation due to an error, the error mode is turned on and cause(s) of the
error is indicated with a corresponding number. This arrangement is intended at reducing nonsense calls from the
users and also for facilitating trouble analysis and repair work in servicing.
(1) Basic Indication Method
1) When SERRORM is selected for the CSMOD (CD mode area for the system), error codes are written to DMIN (min-
utes display area) and DSEC (seconds display area). The same data is written to DMIN and DSEC. DTNO remains
in blank as before.
2) Head unit display examples
Depending on display capability of LCD used, display will vary as shown below. xx contains the error number.
TE
L 13942296513
(2) Error Code List
Code Class
10
Electricity
11
Electricity
12
Electricity
17
Electricity
30
Electricity
A0
System
www
Remarks: Mechanical errors are not displayed (because a CD is turned off in these errors).
Unreadable TOC does not constitute an error. An intended operation continues in this case.
A newly designed head unit must conform to the example given above.
Upper digits of an error code are subdivided as shown below:
.
1x: Setup relevant errors, 3x: Search relevant errors, 3x: Search relevant errors, Ax: Other errors.
http://www.xiaoyu163.com
8-digit display
ERROR–xx
Displayed error code Description of the code and potential cause(s)
Carriage Home NG
CRG can't be moved to inner diameter.
CRG can't be moved from inner diameter.
→ Failure on home switch or CRG move mechanism.
Focus Servo NG
Focusing not available.
→ Stains on rear side of disc or excessive vibrations on REWRITABLE.
Spindle Lock NG
Spindle not locked. Sub-code is strange (not readable).
→ Failure on spindle, stains or damages on disc, or excessive vibrations.
Subcode NG
A disc not containing CD-R data is found. Turned over disc are found,
though rarely.
→ Failure on home switch or CRG move mechanism.
RF AMP NG
An appropriate RF AMP gain can't be determined.
→ CD signal error.
Setup NG
APC protection doesn't work. Focus can be easily lost.
→ Damages or stains on disc, or excessive vibrations.
Search Time Out
Failed to reach target address.
→ CRG tracking error or damages on disc.
Power Supply NG
Power (VD) is ground faulted.
→ Failure on SW transistor or power supply (failure on connector).
x
ao
u163
y
i
http://www.xiaoyu163.com
2 9
8
6-digit display
ERR–xx
OR
Err–xx
Q Q
3
6 7
1 3
1 5
co
.
DEH-P520,P5200,P5250
9 4
2 8
4-digit display
E–xx
0 5
8
2 9
9 4
2 8
m
9 9
9 9
51
Hide quick links:
Advertisement
Table of Contents
