Table of Contents
Advertisement
Assembly
Handle
Assembly
1.
Loosen knobs on mounting brackets (Fig. 1).
Figure 1
1. Knob
2. Handle bracket
2.
Position mounting brackets in a vertical position
so that holes face up.
3.
Slide handle ends into holes in mounting
brackets until handle ends are completely seated
in brackets (Fig. 1). Make sure cables are
positioned on top of left mounting bracket
(Fig. 2).
4.
Rotate handle and mounting brackets rearward
until brackets fit securely into housing pockets
(Fig. 2).
5.
Tighten knobs until edges of slots on top of
mounting brackets touch.
GB–8
3. Housing pocket
6.
Use cable ties to secure cables to left handle
(Fig. 2).
Note:
Make sure cables do not interfere with
the raising or lowering of discharge
door.
Figure 2
1. Cable tie
Starter Rope
1.
Pull starter rope through rope guide on handle
(Fig. 3). By squeezing control bar to handle,
blade brake will release and allow rope to be
pulled up easily to loop.
Figure 3
1. Recoil starter
1694
2. Cables
1690
2. Rope guide
- Quick Links:
- Adjusting Cutting Height
Hide quick links:
Advertisement
Table of Contents
