Configuring The Tdm Vcl And Cesop Connection On The Onu - Huawei SmartAX MA5603T Configuration Manual
Access module
Hide thumbs
Also See for SmartAX MA5603T:
- Hardware description (977 pages) ,
- Hardware description (65 pages)
Table of Contents
Advertisement
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Step 6 Configure an inband management service port.
The management VLAN is VLAN 8, the GEM port ID is 11, and user VLAN is VLAN 8. The
OLT does not limit the rate of inband management services. Therefore, you can directly bind
default traffic profile 6 to the inband management service port.
huawei(config)#service-port vlan 8 gpon 0/3/1 ont 1 gemport 11 multi-service
user-vlan 8 rx-cttr 6 tx-cttr 6
Step 7 Check whether the management service port between the OLT and the ONU is available.
l Run the ping ONU ip command on the OLT to check the connectivity between the OLT and
the ONU. If the ICMP ECHO-REPLY packets from the ONU are received, the connectivity
between the OLT and the ONU is in good condition.
l If you can remotely log in to the ONU from the OLT to perform configurations for the ONU,
the management service port between the OLT and the ONU is available.
Step 8 Configure the traffic profile and create the service port for transparently transmitting services.
Set the service VLAN (SVLAN) ID to 300, GEM port ID to 13, and customer VLAN (CVLAN)
ID to 300. The OLT does not limit the rate of services that are transparently transmitted. Traffic
profile 10 is bound to the service port for transparently transmitting services.
huawei(config)#traffic table ip index 10 cir off priority user-cos 7 priority-
policy tag-In-package
huawei(config)#service-port vlan 300 gpon 0/3/1 ont 1 gemport 13 multi-service
user-vlan 300 rx-cttr 10 tx-cttr 10
----End
Follow-up Procedure
When Config state is failed, Run state is offline, or Match state is mismatch:
l
l
l
l
14.4.7.4 Configuring the TDM VCL and CESoP Connection on the ONU
Issue 01 (2014-04-30)
If Control flag is deactive, run the ont active command in GPON mode to activate the
ONU.
If Run state is offline, a physical line may be broken or the optical module may be damaged.
Check the line and the optical module.
If Config state is failed, the configured ONU capability exceeds the actual ONU capability.
In this case, run the display ont failed-configuration command in the diagnose mode to
check the failed configuration item and the failure cause. Then, rectify the fault accordingly.
If the ONU does not match, that is, Match state is mismatch, the port types and number
of ports undermatch the actual port types and number of ports supported by the ONU. In
this case, run the display ont capability command to query the actual capability of the
ONU, and then select one of the following modes to modify the ONU configuration:
– Create a proper ONU profile according to the actual capability of the ONU, and then
run the ont modify command to modify the configuration data of the ONU.
– Modify the ONU profile according to the actual capability of the ONU and save the
modification. Then, the ONU automatically recovers the configuration successfully.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
14 FTTM Configuration (Base Station Access)
1490
- Quick Links:
- Commissioning Introduction
Hide quick links:
Advertisement
Table of Contents
