Table of Contents
Advertisement
4.1.2 Access to the parts on the front side of the equipment
1 Remove the Inner cover (T).
.
2 Remove the fixing screws(2) (2 pieces) and draw the reservoir unit out to the front
halfway by supporting "a" part (4 places) with both hands.
ａ
Fixing screw(2) Pull out Reservoir Unit
3 Remove the tubes and cables from the clamp.
Clamp
4 Pull the reservoir unit out further and put it on the maintenance cover.
Reservoir Unit
Reservoir Unit
Inner cover (B)
ａ
Tube/Cable
Maintenance cover
Clamp
[CAUTION]
Carefully mount the Reservoir unit back
to its place so that the piping tube of
the recovery filter is not pinched.
After performing the task of pulling the
Reservoir unit, please make sure that the
level sensor is functioning normally Street.
4-2
Rock pin guard
【CAUTION】
Please do not remove the
rock pin guard.
When you removed any
chance, please return to the
original.
Remove
Tube/Cable
- Quick Links:
- Troubleshooting List
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Hitachi IJ UX
Related Products for Hitachi IJ UX
- Hitachi IJ PH
- Hitachi IJ RX2
- Hitachi IJ UX2
- Hitachi IPJ-AW250N
- Hitachi Innovate iPJ-AW250NM
- Hitachi IC25N040ATCS04-0 - Travelstar 40GN 40GB UDMA/100 4200RPM 2MB 2.5" IDE Hard Drive
- Hitachi IC25N080ATMR04-0 - 3E034 - Dell 80GB Laptop Hard Drive
- Hitachi IC25N040ATMR04-0 - Travelstar 40GB Laptop Hard Drive 9.5mm 2.5 Inch Notebook HDD