Cisco nexus 5000 series Configuration Manual page 304
Nx-os layer 2
Hide thumbs
Also See for nexus 5000 series:
- Cli configuration manual (660 pages) ,
- Configuration manual (334 pages) ,
- Command reference manual (196 pages)
Table of Contents
Advertisement
Configuring Fabric Extender Global Features
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
fex FEX-number
Example:
switch(config)# fex 101
switch(config-fex)#
Step 3
description desc
Example:
switch(config-fex)# description
Rack7A-N2K
Step 4
no description
Example:
switch(config-fex)# no description
Step 5
no type
Example:
switch(config-fex)# no type
Step 6
pinning max-links uplinks
Example:
switch(config-fex)# pinning
max-links 2
Step 7
no pinning max-links
Example:
switch(config-fex)# no pinning
max-links
Step 8
serial serial
Example:
switch(config-fex)# serial
JAF1339BDSK
Cisco Nexus 5000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.1(3)N1(1)
284
Purpose
Enters global configuration mode.
Enters FEX configuration mode for the specified Fabric Extender. The
range of the FEX-number is from 100 to 199.
(Optional)
Specifies the description. The default is the string FEXxxxx where xxxx is
the FEX number. If the FEX number is 123, the description is FEX0123.
(Optional)
Deletes the description.
(Optional)
Deletes the FEX type. When a Fabric Extender is connected to the fabric
interfaces and does not match the configured type that is saved in the binary
configuration on the parent switch, all configurations for all interfaces on
the Fabric Extender are deleted.
(Optional)
Defines the number of uplinks. The default is 1. The range is from 1 to 4.
This command is only applicable if the Fabric Extender is connected to its
parent switch using one or more statically pinned fabric interfaces. There
can only be one port channel connection.
Caution
Changing the number of uplinks with the pinning max-links
command disrupts all the host interface ports of the Fabric
Extender.
(Optional)
Resets the number of uplinks to the default.
Caution
Changing the number of uplinks with the no pinning max-links
command disrupts all the host interface ports of the Fabric
Extender.
(Optional)
Defines a serial number string. If this command is configured, a switch
allows the corresponding chassis ID to associate (using the fex associate
command) only if the Fabric Extender reports a matching serial number
string.
Configuring the Fabric Extender
OL-25842-01
Advertisement
Chapters
Table of Contents
