Related Manuals for AEG F45078I-M
Summary of Contents for AEG F45078I-M
- Page 1 F45078I-M Dishwasher Lave-vaisselle User manual Manuel d’instructions PERFEKT IN FORM UND FUNKTION...
-
Page 3: Table Of Contents
CONTENTS Contents INTRODUCTION ........................5 DESCRIPTION AND USE OF THE CONTROLS..............7 Front panel........................... 7 Setting the washing program and switching on and off ..........8 2.2.1 Switching on ..........................10 2.2.2 Selecting and starting the program .................10 2.2.3 End of program ........................11 2.2.4 Interrupting a program ......................11 2.2.5... - Page 4 Rev 0.0...
-
Page 5: Introduction
INTRODUCTION INTRODUCTION Thank you for choosing one of our products. To use this dishwasher cor- rectly and safely, please read this manual carefully. The manual is divided into sections giving you a step-by-step guide to all your appliance’s func- tions. The texts are easy to understand and are complete with detailed illustrations. - Page 6 INTRODUCTION Symbols used in this manual (see tab. 1-01) DANGER. This symbol highlights information and warnings which, if not observed, may compromise personal safety or damage the appliance. This symbol highlights general information and warnings. Tab. 1-01 Rev 0.0...
-
Page 7: Description And Use Of The Controls
USER INSTRUCTIONS DESCRIPTION AND USE OF THE CONTROLS Front panel All the dishwasher controls are grouped on the front panel (see fi g. 2-01). A brief description (see tab. 2-01) of the various elements on the front panel is given below. SANITIZED Fig. -
Page 8: Setting The Washing Program And Switching On And Off
USER INSTRUCTIONS Setting the washing program and switching on and off The dishwasher is equipped with a control panel (see fi g. 2-02) which is used to program the appliance and switch it on and off . SANITIZED Fig. 2-02 To select the most suitable program for the dishes to wash, consult the following tables which specify the most appropriate type of washing sequence depending on the kind of dishes and how dirty they are (see tab. - Page 9 USER INSTRUCTIONS TIME CONSUMPTION PROGRAM NUMBER DISHES AND PROGRAM MINUTES WATER POWER AND SYMBOL CUTLERY SEQUENCE KWh (1) PANS AND DISHES WAITING 6.5 l RINSE FOR THE Cold pre-wash. 16’ 0.03 1.64 gal. LOAD TO BE COMPLETED Wash at 45°C (113°F).
-
Page 10: Switching On
USER INSTRUCTIONS Only run a soak program with half loads. After using the above table to choose the most suitable washing cycle, program the appliance. Before starting a washing program, make sure that: • The water supply tap is open. •... -
Page 11: End Of Program
USER INSTRUCTIONS If you open the door while the appliance is working, you must close it and start the program again by pressing start/pause (ref. 2 fi g. 2-02). The pro- gram will resume from where it was interrupted. If the temperature in the tray exceeds 50°C (122°F), the program will resu- me after about 30 seconds. -
Page 12: Canceling The Current Program
USER INSTRUCTIONS 2.2.6 Canceling the current program To cancel the program press start/pause (ref. 2 fi g. 2-02) until it stops (indicator light on and beep). Press start/pause (ref. 2 fi g. 2-02) once again and hold it down until the indicator lights of programs four and fi ve (ref. pr. 4, pr. 5 fi g. 2-03, marked “end”) light up. - Page 13 USER INSTRUCTIONS To cancel or change the delay of a program once it has begun: • press the start/pause button (ref. 2 fi g. 2-02) for a few seconds until the pro- gram delay indicator light (ref. 6 fi g. 2-02) and the set program indicator light (ref.
-
Page 14: Switching Off
USER INSTRUCTIONS 2.2.8 Switching off At the end of the program, the dishwasher emits a short beep and the indicator lights of the fourth and fi fth program (ref. pr. 4, pr. 5 fi g. 2-04) fl ash. Press the on/off button (ref. 1 fi g. 2-02) to switch off the dishwasher. Fig. - Page 15 USER INSTRUCTIONS Fig. 2-05 Water hardness table (see tab. 2-03) WATER HARDNESS SETTING American degrees German degrees (°D) French degrees (°F) grains/gallon 0 - 4 0 - 7 0 - 4.5 N° 1 NO SALT 5 - 15 8 - 25 4.6 - 14.5 NR.
-
Page 16: Energy Saving And Environmental Respect
USER INSTRUCTIONS ENERGY SAVING AND ENVIRONMENTAL RESPECT • Always try to run the dishwasher fully loaded. • Do not wash the dishes under a running tap. • Use the most suitable washing program for each type of load. • Do not pre-rinse. •... -
Page 17: Removing The Dishes
USER INSTRUCTIONS REMOVING THE DISHES At the end of the washing program, wait at least 20 minute before remov- ing the dishes in order to allow them to cool. To prevent any water droplets on the upper rack from falling onto the dishes in the lower rack, empty the lower rack fi rst and then the upper one. -
Page 18: Troubleshooting
USER INSTRUCTIONS TROUBLESHOOTING The dishwasher can signal a number of malfunctions by turning on various indi- cator lights, as described below (see following table): FAULT DESCRIPTION Acquastop failure The anti-fl ooding system has tripped. Activates in case of water leaks. Contact the technical assistance service. - Page 19 USER INSTRUCTIONS FAULT DESCRIPTION Turbine fl ow-regulator malfunction The appliance is unable to precisely measure the quantity of incoming water. Interrupt the current program and switch off the dishwasher. Switch it back on again, program a new cycle and press start.