Figure 19.20 Mask Rom Addresses And Data; Notes On Ordering Mask Rom Version Chips - Hitachi H8/3062 Hardware Manual

Single-chip microcomputer h8/3062 series; h8/3062b series; h8/3062f-ztat series; h8/3064f-ztat series

Hide thumbs Also See for H8/3062:

Table of Contents

When ordering H8/3062, H8/3061, and H8/3060 with mask ROM, note the following.

1. When ordering by means of an EPROM, use a 128-kbyte one.

2. Fill all unused addresses with H'FF as shown in figure 19.20 to make the ROM data size 128-

kbytes for the H8/3062, H8/3061, and H8/3060 mask ROM versions, which incorporate

different sizes of ROM. This applies to ordering by means of an EPROM and by means of data

transmission.

(ROM: 128 kbytes)

H'00000–1FFFF

Note: * Write H'FF in all addresses in these areas.

3. The flash memory control registers (FLMCR, EBR, RAMCR, FLMSR, FLMCR1, FLMCR2,

EBR1, and EBR2) used by the versions with on-chip flash memory are not provided in the

mask ROM versions. Reading the corresponding addresses in a mask ROM version will

always return 1s, and writes to these addresses are disabled. This must be borne in mind when

switching from a flash memory version to a mask ROM version.

(ROM: 96 kbytes)

H'00000–17FFF

Figure 19.20 Mask ROM Addresses and Data

(ROM: 64 kbytes)

H'00000–0FFFF